This is a replacement Broncolor Halogen Modeling Lamp for the Boxlite softlight.

E14 Base

Related Questions and Answers

Q: 1. Does this unit work with Fujifilm GFX100?

A: It will work.

Q: 2. Should I get RFS 2.1 or 2.2 for X1D?

A: Either RFS2.1 or 2.2 NIkon is suitable and fully compatible with the X1D with the major difference being size, battery (coin-cell on 2.1, AA on 2.2) and control interface, the choice is yours.

Q: 3. Does this unit rfs2.1 work with broncolor move or i need to purchase another receiver to pair with in order to trigger my move wirelessly?

A: The RFS2.1 is compatible with the move 1200L pack, which has an integrated received.

Q: 4. After a month of use I discovered that the translucent diffuser has a thin plastic film on the inner side. Should I remove it?

A: Yes, Litepipe P ships with a protective inner film that can be removed.

Q: 5. Will this Transceiver work with the Broncolor grafit a2 31.169.07 model unit?

A: Unfortunately, this unit will not work with the Broncolor Grafit A2 RFS as the transceiver is not backwards compatible.

Q: 6. Does this unit work with broncolor move ? Or should i purchase another receiver to pair with this transmitter in order to trigger my mover wirelessly ?

A: the move can be triggered by the RFS 2.2. To use the RFS 2.1 you need one unit on each end

Q: 7. does the transmitter turn off?

A: According to page 7 of the PDF MANUAL it enters an energy saving mode at eight hours which may elicit a slight delay if a flash event occurs during this mode Flash triggering is synchronized either via the central contact of the hot shoeor the sync jack of the camera. Outdoors, the remote control range is up to50 m; indoors, it is up to 30 m. The transceiver is powered by a lithium buttoncell (Li-Mn CR2450). To minimise energy consumption, the transceiver is setto an energy-saving mode after eight hours have elapsed. If a flash triggeringaction occurs through the camera whilst the RFS 2 or RFS 2.1 transceiver isin energy-saving mode, a slight delay of the synchronization with the camerashutter release can take place. The RFS 2 or RFS 2.1 transceiver quits theenergy-saving mode after this flash release.attention: although this radio system allows the selection of up to 99 studioaddresses, the number of actually available channels depends on theconnected rFs 2 or rFs 2.1 flash unit. Battery life is listed as 8 - 12 months or 100,000 flasheshttp://www.bron.ch/uploads/tx_bronproducts/RFS2.1_30_09_2013_Englisch_01.pdf

Q: 8. Does the Broncolor RFS 2.1 transceiver work with the H6D-50C hasselblad camera along with siros 800 S?

A: Yes, the RFS2.1 can be used on the H6D-50c via the camera's hot-shoe, or PC sync port. It will sync with the Siros 800S' integrated RFS2 receiver for flash and remote power controls.

Q: 9. Does this transceiver work with the Panasonic S1H?

A: The RFS2.1 is compatible with all standard flash shoes for sync at the camera's rated flash sync speed (X-Sync), but not HS flash sync.

Q: 10. Does this unit have 1 pin contact??? Does its also have PC sync attachment?

A: There is a single pin on the shoe and it accepts a miniphone to PC male cable on the side.