This box contains one Brother Innobella High Yield XL Series Yellow Ink. The Brother Innobella High Yield XL Series Yellow Ink Cartridge is used to produce crisp, clear and colorful prints for home, school or business. Brother ink produces excellent prints with a high-degree of color saturation. When you need prints that display brilliant color and are quick drying, Brother ink cartridges are the way to go. This cartridge will yield approximately 600 pages. The cartridge is designed for the following printers:

• MFC-J280W
• MFC-J425W
• MFC-J430w
• MFC-J435W
• MFC-J5910DW
• MFC-J625DW
• MFC-J6510DW
• MFC-J6710DW
• MFC-J6910dw
• MFC-J825DW
• MFC-J835DW

For the MFC-J280W, MFC-J425W, MFC-J430w, MFC-J435W, MFC-J5910DW, MFC-J625DW, MFC-J6510DW, MFC-J6710DW, MFC-J6910dw, MFC-J825DW, and MFC-J835DW Printers

Related Questions and Answers

Q: 1. Does vignetting occur on all APS-C lenses? What is the formula to determine an APS-C's FF equivalent when used with this adapter?

A: I'm no math whiz but a crop sensor lens is roughly two-thirds of a full frame. So it's already just .66 of the full frame, and even a .71 reducer on top of that pulls the effective focal length of a crop sensor lens on a MFT down below the actual length, and you get vignetting. This .64 will just be worse. Using a crop sensor lens is like having two reducers, if that makes sense, so the image circle is too small for the sensor. I wish I could explain it better.

Q: 2. is this a Micro Four-Thirds to Micro Four-Thirds adapter?

A: No. It is Micro Four-Thirds to Nikon F or DX mount.

Q: 3. Will the Nikon to MFT models work with strong telephoto zoom lenses such as the Tamron 150-600mm lenses on a Panasonic GH5 camera? If so what would the effective focal length be when using a 150-600mm zoom lens on a GH5.

A: The physics of the focal reducer is to concentrate the light such that the light that would normally expand to a larger image circle (that would cover a 35 mm sensor or a slightly smaller APS-C sensor) instead gets concentrated to a smaller image circle. Thus, irrespective of the type of lens (as long as it attaches to it), it will reduce the effective focal length by .63X (or 0.71x, depending on the Speed booster strength you get) relative to an empty-tube adapter. Because of the light concentration, the effective F-stop will increase by one stop for a 0.71x reducer (2^-1/2) or by 4/3 stop for a 0.63X reducer (2^-4/3/2).Finally, because the M43 sensor is 1/2 the area of the 35 mm sensor (the standard from which the advertised focal lengths are calculated) a 2x crop factor is applied because only the light in the center of the lens is detected by the smaller m43 sensor. This is because the 35 mm lens projects an image circle to 2x the area of the m43 sensor. Thus a focal reducer puts more total acquired light onto the m43 sensor.Therefore, a 0.63x focal reducer gives an effective crop factor of 0.63x x 2x = 1.26X from the 35 mm advertised number. This will make your Tamron 150-600mm lens (based on 35 mm focal lengths) a 189-756mm lens on your GH5 FOR TAKING PHOTOS. Panasonic cameras often reduce the amount of sensor used for 4K or 1080p recording compared to taking photos; this will increase the crop factor and therefore increase the effective focal length. However, I think the GH5 uses nearly the full frame for 4K or 1080P video recording, so that the crop factor on your camera for video recording may not be greatly increased relative to that seen for taking photos.To more directly address the first half of your question, it SHOULD work with the Tamron lens, irrespective of the strength of your lens (I presume you mean the telephoto capacity by strength ). Because all you are doing is concentrating light, there may not be an improvement in image quality on relative basis (I have not noticed an improvement in detail in photos, only that the images are constrained to a smaller number of total pixels). It will probably only help if you need to make the image brighter, or are taking an image in a darker environment.

Q: 4. Is there a finite amount of uses for the illuminated bubble level or can it be used indefinitely? Not sure if it needs a battery

A: The ACE XL MKII illuminated bubble is battery powered and there is a limit. The limit would be in years. And you can replace the battery if needed. The ACE head battery replacement is the following. Energizer B/CR1225 Coin Lithium Battery BH #ENBCR1225

Q: 5. Just curious if my vintage Nikon NIKKOR ais lenses would work with this speed booster.

A: Yes this would work with your vintage Nikon Nikkor AIS lenses.

Q: 6. can you snap in the plate?

A: No, the Sachtler Ace XL Mark II Fluid Head (75mm Bowl) uses a slide in camera plate, it will not be able to snap into the mount.

Q: 7. How do I control the aperture with lens that come with the d5200? (18mm-50mm) The lens only has zoom and focus rings.Would I manage it with the f-stops for aperture on the speedbooster? Thanks in advance ;D

A: Yes. You only control aperture by adjusting the f-stops on the speedbooster. It really doesn't matter if you are using a manual or mechanical lens...your aperture is controlled by adjusting the f-stops on the speedbooster. It's a nice smooth rotation as well. I've been using it for a year.

Q: 8. Will this work for the Panasonic AF 100?

A: This will not work properly with the AF 100. The manufacturer claims the older version will fit. I am now returning mine to the manufacturer for an exchange.

Q: 9. How is this version compared to Ultra for Blackmagic Pocket 4K use? Which is best.

A: Speed Booster Ultra models widen the field of view by 0.71x and give you a 1 Stop Increase in Light. While the XL Models give you 0.64x and a 1.3 Stop Increase in light. That is the difference between this model and BH #MESPNFGM43B3. https://bhpho.to/2mFmebJ

Q: 10. Will this head fit on Manfrotto 500BALL 100mm Half Ball Bowl ?

A: This is a 75mm Bowl Tripod head. You will need a 100mm-75mm Bowl adapter to use this in a 100mm half ball bowl.