The K&M 26792 Bearing Plate in black is designed to be used with K&M monitor stands 26790 and 26795. The 12 x 11" plate comes with four spikes and four rubber knobs so it provides adequate stability whether you're on a hard or carpeted floor.

Designed for 26790 and 26795 Stands    Dimensions: 12 x 11"

With both rubber knobs and spikes you get extra stability for your monitor whether its on a solid surface or carpet.

This plate is designed specifically to fit the 26790 and 26795 monitor stands so you can be sure you're getting just the right foundation.

Related Questions and Answers

Q: 1. Will this fit Manfrotto Befree live fluid head tripod?

A: I'm sorry, no. You will need part # MA501PL.

Q: 2. Can this be used for panorama (with left/right slide)?

A: As a pathologist, I was trained in macrophotography of surgical or autopsy organ specimens. This specialized type of lens/camera cradle is designed to perform the following: 1. Permit the normal lens focusing for general composition 2.Lock the camera/lens together as one rigid unit and then, using a combination of the tension and focusing knobs, finely move them forward/backward for final focusing. At these distances D.O.F. is minimal: rigidity and enough lens clearance for shadowless lighting and, often, backlighting are required. Obviously, lateral or rotary movement, such as for panoramas, are not pertinent.I am an active customer of B&H; I went into this detail to help your company understand your product. There are, doubtless, good books on panoramic photography, but mine is from 1996 - obsolete.Regards,Harold Block, M.D.

Q: 3. Will this plate fit my Manfrotto 504AH head?

A: No.

Q: 4. What is the total distance of travel that this device will allow?

A: 4 1/2 inches is the total range of movement

Q: 5. Does Manfrotto allow for hanging the camera strap from the D-Ring? My camera is a Canon 5D mk3 with a Sigma 35 1.4 at the heaviest.

A: The D-ring on this plate is not designed to support the weight of a hanging camera and will most likely break if you hang your camera from it.

Q: 6. Will this fit the 475B tripod?

A: That would depend on which head you have mounted on the 475B legs.

Q: 7. Does the plate fit on the Manfrotto 055 Tripod?

A: The Manfrotto 055 are tripod legs, we would need to know which head you are using.

Q: 8. The groove for adjusting camera position is asymettrical on the plate. Why? Which is the front end?

A: The knob to adjust fore and aft positioning in the Manfrotto 454 Micrometric Positioning Sliding Plate is usually placed on the left of the camera so that you can take photos with your right hand and control the fore and aft with your left hand.

Q: 9. What number plate is this? 501?

A: The Sachtler Sideload Plate S/Ace Tripod QR Plate (B&H# SAWPDV1) is a Sachtler #0164 plate. It seems like you might be looking for a comparison to a Manfrotto plate, however, in which case we'll mention that it is most similar to a Manfrotto 504PLONG Long Quick Release Mounting Plate (B&H# MA504PLONG). See below: https://bhpho.to/3XtNERk

Q: 10. Will it fit a 3411?

A: The Bogen 3411 was a tripod, not a head. We would need to know the model number of the head that is on that tripod.