The Manfrotto 131D Side Arm mounts on the center post of tripods with a 3/8" thread. It allows easy shooting straight down to the ground without having to get the tripod column and legs into the picture. Double-sided screws (1/4-20" on one side, 3/8" on other) enable cameras to be mounted on either or both ends.

Replaces old part number 3059.

To Mount 2 Cameras at 90°    Replaces #3059

Related Questions and Answers

Q: 1. will this work with the 290 xtra?

A: No it will not. The diameter of this tube is too big.

Q: 2. Will this work on an 055CX3?

A: Unfortunately, this column is not compatible with the O55CX3.

Q: 3. is it compatible with MT055cxpro3?

A: Yes, this is compatible with the MT055CXPRO (also known as the CXPRO3 3-section).

Q: 4. Will this fit the 190GO aluminum tripod?

A: No, this is not for the 190Go tripods.

Q: 5. does manfrotto make any short center columns for 055 so camera can be placed lower to ground?

A: The shorter center column that would work with the 055 is item # 055XSCC however it appears that B&H doesn't carry it. You can find it either on the Manfrotto website or through other dealers. That column is about 9.76 in length.

Q: 6. Is it possible to spin this operational dolly through a 31" residential doorway?

A: Listed in the main overview section of the Manfrotto 114 Heavy-Duty Cine/Video Dolly for Tripods with Round Feet, it states Doorway clearance needed for the fully assembled dolly is only 44.1".

Q: 7. Will this work with the 755XB?

A: No, the Manfrotto 055XSCC Shorter Center Column is designed and made for the following models. MAMT055XPRO3 MAMT055CXPRO MAT055CXPRO4

Q: 8. I have the MT190cxPro4 tripod and am interested in this shorter column so I can keep the head I use for portraits on one column and keep the ball head for landscapes on the other. Would swapping the columns require tools or does it simply pop out when fully extended? Ideally I'd prefer to just swap columns while shooting rather than swap heads on the same column. Thanks!

A: Yes you just swap columns. I use it the same way. There is a bit of getting used to swapping them though. The original one can be a bit hard to remove till your Ok with it.

Q: 9. I have an older Bogen/Manfrotto 3021PRO tripod with 055PRO/LF13 engraved on it. Will this shorter column work on it?

A: Unfortunately not, this is a different cut for the column.

Q: 10. Does the Manfrotto 114 dolly fit a Manfrotto 161MK2B tripod? Or can you recommend one that fits please?

A: Yes, the Manfrotto 114 Heavy-Duty Cine/Video Dolly for Tripods with Round Feet will accommodate the Manfrotto 161MK2B Super Professional Tripod Mk2.