This is the NEC NP-07LP Projector Lamp designed for the NEC NP300, NP410W, NP400, NP500, NP500W, NP500WS, NP510W, NP510WS, NP600S, NP600, NP610, and the NP610S projectors.

Designed for the NEC NP300, NP410W, NP400, NP500, NP500W, NP500WS, NP510W, NP510WS, NP600S, NP600, NP610, and the NP610S Projectors

Related Questions and Answers

Q: 1. Charge via D_tap with older swit charger for the NPL60? charger model Model DSS168100

A: The D-Tap connections are listed as outputs only. We are not aware of this battery being able to be charged through D-Tap.

Q: 2. Why would I use the low-power charging mode? Is there any downside to the high power mode? I have this charger but don't know.

A: The SHAPE NP-F980 Dual Charger with Two 6600mAh Lithium-Ion Batteries (B&H# SHNPF2B) offers what the the manufacturer calls a high-current mode and also a low-current mode. While the voltage is the same, the former (high-current) would typically be used for larger batteries or for a faster charge. The latter (low-current) mode would be used for the smallest batteries (e.g., 2500mAh and below) or to minimize the heat that is generated when a battery is charged. While it is best to allow a battery to cool before recharging it at all, if you needed to begin charging a warm battery immediately after use then it would be best to use the low-current mode at least until it cools down. Extreme heat (and cold) can damage batteries.

Q: 3. An article on 4kShooter said that this battery has a 12 volt output port (like the Powerextra batteries had before they changed the design). DOES THIS HAVE A 12v OUTPUT? Barrel connector? D-Tap?

A: Hello Steve, Thank you for your question! Unfortunately, it doesn't have a 12V output, no D-Tap or barrel connector either. Only a 5 Volt Micro-USB connector on the side. We hope this helps and we thank you for your interest in our products. The SHAPE team

Q: 4. Hello. Is it dual battery charger?

A: Yes, the SmallRig NP-FZ100 Camera Battery Charger can charge two batteries.

Q: 5. Will this charger charge the newer version of the battery that is not included, which is the "NP-BX1/M8"? And will the included batt work with the RX100vii?

A: Yes, this will charge the NP-BX1/M8 and will work in the RX100 VII.

Q: 6. Will this battery fit inside a Blackmagic 6K Pro? The actual camera, not the battery holder.

A: Yes, the Newell NP-F570 USB-C Battery for Sony is 570 size battery and should work in the Black magic Pocket 6K pro cinema camera. However, it has not been tested. We only recommend the Black Magic model listed below. Blackmagic Design 3350mAh Li-Ion NP-F570 Compatible Battery BH #BLBNPF570CAM • MFR #BATT-NPF570/CAM

Q: 7. Is this compatible with X-H2? Description only lists "FUJIFILM GFX 50S II, GFX100S, and X-T4 cameras"

A: The SmallRig NP-W235 Camera Battery Charger is compatible with the FUJIFILM NP-W235 Lithium-Ion Battery (7.2V, 2200mAh) included with the FUJIFILM X-H2 Mirrorless Camera.

Q: 8. Can this be charged with the IDX JL-2plus charger?

A: The IDX System Technology JL-2PLUS specifications state JL-2PLUS compatible batteries: All NP Li-ion/Ni-CD/Ni-Mh batteries. So practically speaking, it would seem it will charge the SWIT S-8073N 73Wh NP-1 Battery. However, since this is a mix of manufacturers, we would assume that such a combination is not supported by either company's warranty.

Q: 9. Will this battery work with GVM 50ORS LED light?

A: Yes it will

Q: 10. Hey there, would you recommend these batteries for the Z Cam E2 M4 and the ANDYCINE A6 5.7" Full HD HDMI On-Camera Monitor?

A: Yes, this is a great battery to use with either.