Enhance the safety of your office or set with the black 4" x 30' Safcord Cord and Cable Protector for Carpet. This hook-and-loop cable cover secures easily to your carpet, reducing the risk of trips and falls. Made of ballistic nylon, it features a washable, reusable, and cut-to-fit design.

Secures Electrical Cords to Carpet    Hook-and-Loop Fastening    Cut to Desired Length    Durable Ballistic Nylon    Reusable, Washable Design    Easy to Install, Remove, and Transport    Indoor and Outdoor Use    OSHA Compliant

• Easy to use hook-and-loop design
• Eliminates stick tape residue
• Low profile solution

• Enhances safety by securing cables and cords to looped carpet
• Stays in place until you lift it

Washable, cut-to-fit material

Related Questions and Answers

Q: 1. Does this Remote Release Cord have pre-trigger switch (half press/full press) that will allow one to wake or sleep the camera similar to using the camera's shutter release?

A: It does have a delay - and a slider that hold until you release it (so many seconds) to take the image

Q: 2. Does it work with Nikon D850?

A: No. The correct cord for a D850 would be the MC-36/MC-36A Multi-Function Remote Control Cord (uses the 10 pin connector).

Q: 3. DOSE the Nikon MC-DC2 remote release cord with Nikon D70 & D300 CAMERA ?

A: No. The MC-30/MC-30a works with the D300 and D300s. For the D70, the only remote is the infra red remote ML-L3 which only works in front of the camera (180 degree - side to side). I have found a reference to a MC-DC1 for he D70S but do not know if this will fit the D70 itself.

Q: 4. Will this work with the nikon 1 j4?

A: No, look for Nikon's wireless release.

Q: 5. Will this work on the D60?

A: No. According to the manual, the only cable release is the ML-L3 wireless remote. Wireless Remote Control ML-L3Use as a remote shutter release for self-portraits or to prevent blur caused by camera shake.The ML-L3 uses a 3V CR2505 batter (Page 156 D60 manual)

Q: 6. Is the Nikon mc dc 2 a intervalometer

A: No, the Nikon MC-DC2 Remote Release Cord is a simple shutter release. For an intervalometer we have the Vello ShutterBoss II Timer Remote Switch for Cameras with Nikon DC2 Connector, BH #VERCN22 (https://bhpho.to/3FefCdG).

Q: 7. Does this work with the new Nikon Coolpix P1000?

A: Yes.

Q: 8. Does this remote work with the D500?

A: It works fine on my D600 - you would think B&H could find out if it's compatable with your D500.

Q: 9. Is this compatible with a Nikon F6 ?

A: No. You can use the Nikon MC-30 Remote Cord.

Q: 10. Can it be used to create rapid fire----8 fps ?

A: If your camera is set to burst mode, you can use the shutter lock button on the remote to continue to depress the shutter for burst photographic needs. The burst rate would be determined by your camera, not by the remote.