Patterns, or gobos, are widely used by designers in theatre, film, photography and television to create atmosphere, project scenery, and generally enhance the visual impact of their lighting.

Conceived by some of the world's leading lighting designers, the Rosco range presently includes hundreds of standard steel gobo designs.

To insure design integrity the patterns are etched using a precise double-sided process on stainless steel. The result is durable, high quality patterns which will withstand the extreme heat at the gate of ellipsoidal spotlights.

Rosco steel gobos are round to allow for rotation in the gate when aligning the projected image.

The standard "B" size is suitable for most fixtures with a 6" lens when used with a Rosco Pattern Holder or the holders of other manufacturers.

Trimming of patterns, where necessary, can be easily accomplished with a pair of scissors.

Related Questions and Answers

Q: 1. What size is recommended for the iPhone XR?

A: An iPhone XR will fit this case: iPhone XR dimensions: 5.9x3x0.33 in. Compatibility Devices up to 6.3" (16.0 cm) in height and up to 7.9" (20.0 cm) in circumference.

Q: 2. Would the Aquapac work well for snorkeling? Is it leakproof/waterproof at the surface?

A: I had no problems with it leaking on a trip to FL. Like it.

Q: 3. does this mount a QNAP QSW-M804-4C switch ?

A: No, the QNAP QSW-M804-4C comes included with its own rackmount kit for installation into a 19" rack. The Standard Rackmount Unit is not meant for the QSW-M804-4C

Q: 4. Does it work for iPhone 7 plus?

A: Yes, this would work with the iPhone 7 Plus.

Q: 5. What are the exact gobos included?

A: Please find an image of the 10 holiday gobos included on the manufacturer's website https://www.chauvetdj.com/products/gobo-shot/

Q: 6. I love this cutter but how do you replace the razor blade?

A: 1-put finger under ribbed portion of sliding blade holder top and pull up. As it swivels (rotates) up it will expose blade2-Slide plastic holder of blade at top side of blade over,3- grab blade from top protected end and pull it strait up and out of holder.(it slides out sideways)4-slide new blade in exactly in reverse of how you pulled old blade out.5-slide plastic holder back over new blade top holding it in.6- Swivel (rotate)top of sliding blade holder back down into position and your ready to go.7- once you know how to do it the whole process takes ten seconds.

Q: 7. What icc profiles settings should I use with this paper and the Canon ipf8400? Thanks!

A: I created my own profile for the Canon ipf6300 using a Spyder 3 print. It seems an improvement. I've uploaded he profile to http://davidsutton.co.nz/profiles/ and you are welcome to try it if you like. I'll leave it there for a few months.David Sutton

Q: 8. How do you know the proper size?

A: At the bottom of each glove's page in its description, there are instructions and measurements for the size you need based on the circumference of your hand.

Q: 9. Would it fit on IPhone 6?

A: Yes. An iPhone 6 will fit nicely. The case is designed for phones up to 6.3" (16.0 cm) in height and up to 7.9" (20.0 cm) in circumference.

Q: 10. Will this trim a 13x19" sheet of photo paper to 12 x18"?

A: You will have trouble trimming 13" to 12". The Falcon Marshall can only cut up to 14". When you rotate the paper, you will only be able to trim one inch off that side, since you can only reach 14" on the long edge.