The 25' Standard PC Power Cord by Comprehensive is a replacement power cable for your PC, monitor, printer, scanner and most any other device that uses the 3-pin shroud power connector. The cord features a fully molded design providing maximum flexibility and long-lasting durability and is backed by Comprehensive's limited lifetime warranty.

Replacement or Spare Power Cable    Durable, Fully Molded Design

25' (7.62 m) replacement power cord for PC's, monitors, printers, scanners and more

Fully molded cable provides maximum flexibility and long-lasting durability

For use in 120V power outlets that accept NEMA 5-15P connectors

Backed by Comprehensive's limited lifetime warranty for ultimate peace of mind

Related Questions and Answers

Q: 1. 3 ANSWERSWill this work with the Nikon D500?

A: When I looked up the MC-DC2, it doesn't list the D500, but when I looked up the D500, which is probably a much newer entry, it says MC-DC2 Remote Cord works, by using an accessory terminal.

Q: 2. For a D7100, does the camera have to be in remote control mode to use the remote release cord?

A: In my experience, I simply plug the cord into my D7100 and the remote works. I don't use a different setting or change anything on my camera.

Q: 3. Does this work with the Z6?

A: Yes it is compatible with the Z6.

Q: 4. does it work with Nikon Z50 or z fc ?

A: Unfortunately, the MC-DC2 does not work on the Z50 or Z fc. Neither camera has a remote cable slot.

Q: 5. Will this work with the new Nikon ZF

A: Unfortunately the Nikon MC-DC2 Remote Release Cord is not compatible with the Nikon ZF camera. The ZF can only use the wireless bluetooth remote. Please take a look at the following link: https://bhpho.to/2uiKuo1

Q: 6. Does it work on a Nikon D750 in combination with Really Right Stuff L-Plate in vertical camera position?

A: Yes it works well.

Q: 7. Is there an exposure limit with this? I believe the cheaper IR remote has a limit of 30minutes but cannot find anything like that about this chorded release

A: There is a physical slider button that holds down the shutter button indefinitely until it is slid back, so I would assume any exposure limit with be in the camera itself.

Q: 8. Will this MC-DC2 work on Nikon D700 Camera?

A: It works on both my Nikon D7200 and D5100, best I can tell you.

Q: 9. Will this MC-DC2 allow the Nikon D610 to make long exposures over 30 seconds like 1 ,2 or even 5 minute exposures??

A: Yes. It works great on bulb mode. The button that you push to activate the shutter will slide up into a hold position.

Q: 10. Will this work with the Nikon Zfc camera?

A: No, the Nikon MC-DC2 is not compatible with the Nikon Zfc. A compatible remote would be the Revo RBL-N Bluetooth Remote Shutter Control for Select Nikon Cameras, BH # RERBLN. https://bhpho.to/3B5OBaI