The black EVF-1152D Single 15" 2-Way Full-Range Outdoor Loudspeaker System from Electro-Voice is a high-power, 2-way loudspeaker system that can be used in a variety of applications where high-quality sound reinforcement is required. It utilizes the DH7N 3” titanium compression driver, coupled to a Constant Directivity 60 x 40° waveguide. The system also uses DVX3151A 15” woofer, developed using FEA optimization for motor, suspension, and electrical design to ensure very low distortion, high efficiency, and maximum intelligibility at high SPL. The crossover uses steep, 24 dB per octave slopes with equalization for very smooth response in the vocal range, linear off-axis response, and a protection circuit for long-term reliability.

The trapezoidal enclosure is constructed of weather-resistant birch, and coated with fiberglass for maximum protection from extreme outdoor elements. Thanks to the fiberglass finish and IP55 rating, this loudspeaker can be used in harsh environments. The acoustic and rigging design allows for vertical and horizontal clusters to be built using any combination of loudspeakers from the entire EVF and EVH series. A 70.7/100V transformer kit can be easily mounted to the input panel for use in distributed systems.

The system offers 7 horn patterns with an assortment of low-frequency and subwoofer loudspeakers to maximize flexibility of system design as per your requirements. The input panel features a Phoenix-style connector and CDG dual-gland-nut input panel cover. In addition, an externally accessible jumper selects passive or active operation.

DH7N 3" diaphragm and 1.4" exit pure titanium compression driver

DVX3151A 15" LF transducer with a fully symmetric drive

Comes with a Phoenix-style connector and CDG dual-gland-nut input panel cover

Fourth-order crossover network with HF protection

Coverage pattern of 60 x 40° and Constant Directivity 12" rotatable waveguide

100 dB sensitivity and 134 dB maximum SPL

Twenty-two M10 threaded suspension points

Related Questions and Answers

Q: 1. Is the TTL on this unit compatible with the Hasselblad 1xd II using the Nikon trigger?

A: Godox has not confirmed that their Nikon radio transmitters will work in TTL mode with the Hasselblad X1D II 50C Medium Format Mirrorless Camera. However, most users who own the Hasselblad X1D II 50C Medium Format Mirrorless Camera state that Godox strobes do not have TTL compatibility when used with the X1D II, but you can set the transmitter and flash to manual mode and set the flash output manually, which would be compatible for use with the Hasselblad X1D II.

Q: 2. What is the warranty period and terms? Is it a B&H warranty, Godox, or other?

A: The warranty period is for 1 year and it is by Godox. A 1 year limited warranty which is for manufacturer defect.

Q: 3. Can this model plug into and outlet to charge the battery while using the monolight? Is a battery charger available?

A: Technically yes, but your recycle times are a lot longer if the battery is nearly dead.

Q: 4. Is the lens hood improved (e.g., similar to the 300/4), or is it the same break-prone one? (I've replaced mine twice$.)

A: The lens hood on the OM SYSTEM M.Zuiko Digital ED 40-150mm f/2.8 PRO Len has not changed from the pervious version.

Q: 5. What's the best way to run this strobe on a C-stand? The baby pin of my C-stand doesn't go far enough into the Godox in order for the baby pin's dimple to align with the tightening screw of the Godox.

A: You can still use a pin on the grip at the end of your extension arm, but I would recommend the Avenger E250 Long Double 5/8" Baby Pin, BH # AVE250. This model has a notched end which will have a better fit with the AD600 Pro. https://bhpho.to/2FCKgSs

Q: 6. does it work with canon R5?

A: Yes. Firmware updates have been put in place.

Q: 7. Is the tip of this lens waterproof? Can it be used inside of an aquarium or small body of water like a tide pool? If so, up to what point on the tube is is waterproof?

A: The Venus Optics LAOWA 24mm T14-40 Full Frame 2x PeriProbe Cine Lens (PL Mount) does have a waterproof front barrel, allowing users to underwater shots with out additional water proofing. You can only submerge the lens a few inches.

Q: 8. Can the Godox AD600Pro be triggered with my PocketWizard MiniTT1 transmitter from my Nikon camera?

A: You may use any standard PocketWizard radio transceiver/receiver, such as either the PocketWizard FlexTT5 Transceiver Radio Slave for Nikon i-TTL Flash System, B&H # WIFTT5N, or the PocketWizard PlusX Transceiver, B&H # WIPWPX, connected to the 1/8 (3.5mm) miniphone sync terminal on the bottom of the Godox AD600Pro Witstro Flash using the PocketWizard MM1 Miniphone to Miniphone Cable -12 , B&H # WICMM16. However, do note that this will simply allow you to wirelessly trigger the flash. You will not have TTL or High Speed Sync capabilities, and you will have to set the flash output power manually on the monolight, as there is no option to wirelessly control the flash output power using the camera-mounted remote.

Q: 9. What is the diameter of the zoom ring on this lens? (for using with FIZ motor adapters)

A: The outer diameter on the OM SYSTEM M.Zuiko Digital ED 40-150mm f/2.8 PRO Lens zoom ring is 78mm.

Q: 10. Ad1200 pro

A: That is the AD600 which is a Monolight strobe. The AD1200 is a pack head system, https://bhpho.to/3MFCOmH