Keep your Aquatica A7D Mk II underwater housing watertight with this O-Ring Maintenance Kit. For complete camera compatibility information, please see below. The kit contains a full set of replacement O-rings for the enclosure, i.e., one large main seal and two smaller seals for the port and extension, along with a container of silicone lubricant to keep the rings from drying out and cracking.

Aquatica's neoprene O-rings are built to withstand extreme temperatures and are highly resistant to harsh solvents. After changing any O-ring, a pressure test or immersion without a camera inside the housing is mandatory. Failure to perform this test could result in serious damage to your camera and lens if the O-ring is improperly installed.

1 Main Housing O-Ring    2 Port/Extension O-Rings    1 Container of O-Ring Lubricant

Canon 7D Mk II

Related Questions and Answers

Q: 1. Is the battery compartment isolated from the rest of the electronics?

A: Yes, and it is fully sealed against leakage.

Q: 2. Is this housing compatible with the Ikelite AF35 strobe?

A: The Ikelite AF35 strobe is NOT compatible with the Ikelite Underwater Housing for Canon PowerShot G7X Mark II. You need to use a strobe that uses a fiber optic cable. Please email uw@bhphoto.com for compatible strobe options.

Q: 3. Will this work on the PT 059 housing?

A: The Olympus O-Ring for PT-058 Underwater Housing is also compatible with the PT-059 housing.

Q: 4. Is it possible to use the side grip with this housing?

A: no

Q: 5. Will a Nikon d7100, 18-140mm lens with a SB-700 flash fit?

A: this outfit will fit in the UBXP however if you have lenses with an 82 mm filter thread then you will require the U-BXP 100.

Q: 6. hi, May I know what is the distance from the opening in the camera to the opening of the housing? Is the vacuum check system same as the Aquatica surveyor kit? Lastly, the housing will be tested before shipping right?

A: Aquatica pressure test all housings before shipping. The included vacuum check system with the Aquatica Underwater Housing for Sony Alpha a7R III or a7 III with Vacuum Check System is the SURVEYOR pressure valve and vacuum pump. To check housing specs that are not listed under the spec tab email us at uw@bhphoto.com.

Q: 7. Where is this made?

A: This light is made in Japan.

Q: 8. Hi all, I purchased this housing and tried it for scuba diving. Unfortunately, I could not get the mode dial to work in this housing. Anyone knows what the issue might be? I read the manual attentively and aligned the camera before closing the housing, but still didn't succeed. I will greatly appreciate your advice! Except for this issue, I really like this housing

A: Hi Marina, I send you e-mail privately Regards Ran Vered Fantasea Line info@fantasea.com

Q: 9. will this work for a sx740?

A: The Ikelite Underwater Housing for Canon PowerShot SX730 is also compatible with the Canon PowerShot SX740.

Q: 10. This housing is compatible with Sony A6000?

A: Yes is perfect