Finish your installation with a clean look with the black Whirlwind WP1B/1MW 1-Gang Wall Plate. It features a single-gang design with one Whirlwind WC3M male XLR terminal to pass your wiring through the wall, reducing the appearance of cable clutter.

1x Whirlwind WC3M Male XLR Terminal    1-Gang Design

Related Questions and Answers

Q: 1. What is the length of each segment -- that is, from an individual XLR plug to where it enters the four-cable bundle, and the segment where the four cables are bundled together? For instance, if the "fanned" portions were 2' each and the bundled portion were 10', it would be 14' from a male XLR plug to its matching female plug.

A: I just measured my cable, and each fan is approximately 2' and the bundled segment is about 6', so the total length (XLR male to XLR female) is the advertised 10'. You do not get a "bonus" 4' due to the two fans -- their length is included.

Q: 2. Hi. Does this check phase also?

A: It ONLY tells you if your cables are correctly wired or not. It will not tell what the specific problem is IF there is a problem. This is a very basic, albeit well-made, device. I use it to identify bad cables in the field.

Q: 3. I am new to this and see that there might be a difference between BNC connectors. Will this test a BNC plug RG58 Coax Coaxial Cable Kable 50ohm RF?

A: Yes, the Whirlwind MCT7 Multi Connector Cable Tester is capable of testing both 50 and 75 ohm BNC coaxial cables.

Q: 4. Is this model made in USA or China?

A: The Whirlwind SELECTOR is made in the USA.

Q: 5. Can you use an additional inline barrel pad on top of this in case you need to knock a signal down to mic level?

A: The output is already at mic level. The transformer gives you a 20 dB loss from -10 consumer line input to -30dB. If you need more, there is a built in 20 dB pad switch which takes your signal down to -50dB total. There is no reason or need to use an additional pad.

Q: 6. will this test 4 pole speakon connections?

A: The MTC-7 from Whirlwind is capable of testing 4 pole Speakon connections.

Q: 7. do you have to have a mixer to use this?

A: No. I use it to go from stereo 1/8 sources (like laptops and cell phones) to one or two XLR's that I then put into a mixer, personally. But you could plug your XLR's into a combo amp or whatever else you want.

Q: 8. Is this compatible with Dante?

A: The SoundTools WallCAT WC851 Analog Audio Over Cat5 Wall Plate (White), BH #SOWC851W, is not Dante compatible. It will easily send or receive four channels of XLR, AES3, DMX or intercom over Ethernet cabling to multiple locations.

Q: 9. Does the stated length (10') include the fan length, or is the male-xlr to female-xlr length 14' (assuming each fan is 2')?

A: Yes it includes the connectors total legnth

Q: 10. What gage wire is used in each channel line. And what kind of connectors

A: The wire gauge used is 24 gauge. The connectors used are manufactured by Neutrik to Whirlwind specification with longer barrels and durable laser-etched markings.Options include Snakeskin (TM), wire mesh hanger grips, and additional connector configurations.