Power up to four accessories at the same time from your Gripper battery with the Gripper D-Tap 1x4 Adapter from Zacuto.

A special feature of this adapter is that, just like the Gripper batteries, it's designed to clamp right onto a 15mm rod. It connects directly into the D-Tap connector on the Gripper GR-100 or GR-75 battery. It measures 15" end-to-end, with the cable making up 11".

Power 4 Devices from the Gripper Battery    Clamps Right onto 15mm Rod    Measures 15" End-to-End, with 11" Cable

Related Questions and Answers

Q: 1. Can this be used to split the video output to a monitor and to a Teradek Cube in a Canon C-300 Mark II?

A: You could use this to split the HDMI signal from a Canon C300 to a monitor and a Teradek Cube. However, this device is better for permanent installations. If that is what you are doing, that is fine. However, for splitting the HDMI signal while on set in active situations, we suggest using a monitor with a HDMI loop through to the Teradek as a more convenient solution.

Q: 2. What is the maximum recommended current draw?

A: The Watson Pro D-Tap 1x4 Splitter Cable uses 18 AWG wire, that is good for a total of about 5 amps So if your source is 12 Volts the max you should connect is a total of 60W. IF your source is 5 Volts, 25 watts is your max load

Q: 3. Can this be charge using the Core SWX PB70C PowerBase Charger?

A: Yes, you can use the Core SWX PB70C PowerBase Charger to charge the Gripper Series GR-75 Clip-On Battery. It would take about 4.5 to 6 hours depending on the state of the battery's charge.

Q: 4. is the strap cut resistant?

A: There is no indication from either the manufacturer or any other source that the Domke 2" Gripper Strap for F-1, F-2, F-3, f-4 or F-7 Bag (Black) is cut proof.

Q: 5. Is it include Charger or not ?

A: The GR-75 does not include a charger. You would need to purchase the Gripper Single Battery Fast Charger or Dual Battery Fast Charger as well to charge this battery.

Q: 6. Can I charge the battery with any d-tap charger or it has to be the Gripper Series Charger?

A: No, I highly suggest using the dedicated charger for the unit at it is rated and regulated properly to charge the unit within a 3-4 hour window. Gripper Series Gripper Single Battery Fast Charger https://bhpho.to/3rXPyM4 using a third part charger could cause damage to cells in battery or worse.

Q: 7. What is the length?

A: The strap length is approximately 60.

Q: 8. Can you charge this battery using the Core SWX PB70C PowerBase Charger B&H # COPB70C MFR # PB70C?

A: That combination has not been tested or reported and so will not be able to recommend it. We would suggest using the recommended charger rather than risking damaging the battery. Gripper Series Gripper Single Battery Fast Charger B&H # GRGR1C.

Q: 9. How long can the battery keep the c200 alive?

A: This is a 100 Wh battery and the C200 has a typical power consumption of 19.3 Watts while recording. You should expect to get around 5 hours of recording time with this battery.

Q: 10. If the input is sending audio as well as video will this output audio as well as video to both outputs?

A: Yes, the KanexPro 1x2 HDMI Splitter will passthrough audio up to uncompressed LPCM to both outputs as well as video.