The AC3PDMXPRO ACCU-Cable 3' Long 3-Pin Pro DMX Cable from American DJ is useful for short DMX runs when daisy chaining units together. It uses 3-pin XLR connectors, which should not be confused with standard audio cables. This is the Pro version that incorporates PVC Jacket to prevent kinking at the connector and extend the life of the cable. The connectors are heavy duty and more durable than the connectors on the non-pro cables, which makes these cables suitable for use on set or location.

Cable Specifically for DMX    3-Pin XLR (Male and Female)    3' Length for Short Runs

Related Questions and Answers

Q: 1. When using several of these can I sync them? For example, if I place units on the same DMX channel, set the speed to 4 flashes per second and then enable them by setting the intensity from 0 to my desired level will they begin flashing at the same time and maintain synchronization? Alternatively, can I control individual flashes by setting a slow flash rate and then retrigger by setting intensity to zero and then back to get a "flash on demand"?

A: According to the manufacturer when on a control board they will sync and act as one unit.

Q: 2. Is this compatible with the Aputure Amaran F21/22 fixtures?

A: No, the PILOTCINE Atomcube DMX-D3P 3-Pin Cable for RX50/RX7 with PD 3.0 Charging Support (9') is not compatible on the Amaran f/21/22 for dmx.

Q: 3. What are the internal dimensions of the individual compartments that are said to store LED lights?

A: the dimensions are 9Lx9Hx3.25W per slot (inches)

Q: 4. do you Daisy-Chaining them?

A: yes you can daisy chain the dimmer packs

Q: 5. Does this board work with led pars

A: This can be used for LED Pars but is not ideal for them as each fader will access one feature of the LED par so depending on the channel mode you can burn through channels quickly. If you have several pars set to the same dmx channel and can get by with 48 channels than this will work for you.A better option for LED pars is the RGB3C IR or the RGBW 4C IR as there are presets and built in programs. These are specifically built for LED pars.Another option would be something like the DMX operator series or the Show designer 1 if you wanted run scenes and programs that you have created, but not adjust colors on the fly (as this can be cumbersome with this option).

Q: 6. Would this fit 2 smaller moving heads?

A: I purchased this bag particularly for that reason. It fits 2 - ADJ Pocket Spots just perfectly.

Q: 7. Is there a way to turn on sound active mode when in DMX mode?

A: Sound activation mode is only adjustable on unit itself.

Q: 8. Will this case fit 4 x Genaray Escort Daylight LED Spot Light (B&H # GEESDS25) in their original case?

A: the dimensions are 9Lx9Hx3.25W per slot (inches)

Q: 9. Will this cable work with an Aputure 120dII or 300dII?

A: The American DJ IP65 Power Link to Edison 3-Prong Power Cable, 25' is not compatible with either Aputure 120d II or the 300d ii. For this cord best is to contact Aputure direct.

Q: 10. Is this only for LED lights?

A: The ADJ Stage Pak 1 Controller & Dimmer Pack System can be used for tungsten lamp heads as well as long as they do not exceed the 1800 watt limit on each dimmer pack.