The Dutti Dolly Universal Stand Bracket from Matthews is used to support 0.75 to 2.25" diameter round or square track sections. It can be mounted on stands that have a baby or junior pin using an included receiver, or used on flat surfaces. The stand is designed specifically for use with the Dutti Dolly, with the track slots having a center-to-center distance of 16".

Note: A minimum of two Dutti Dolly Universal Stand Brackets are required—one at each end of the track.

20 x 24" Dolly Supports up to 800 lb    Low, < 2" from Ground Platform Height    75/100/150mm Bowls with 2.5" Riser    3 x Track Brackets, 2 x 3/8 to 5/8" Pins    Carrying Case    Works with or Without Track    Use with Speed Rail or Hardware Tubing    Integrated Mitchell Mount

Related Questions and Answers

Q: 1. Does this need 3 Slider Stands since it has 3 track brackets ?

A: Yes it does.

Q: 2. What case is it in ?

A: Unit comes in a custom SKB case. Made in the USA which makes them GOV compliant

Q: 3. Can I use this item with Kessler Crane K-Flex Dolly Track?

A: The Dutti Dolly wheels will track on the Kessler K-Flex system.

Q: 4. What is the width of the track from the center of each pole support?

A: You can order the pipe in any length you want...after 7' you will need support...go to the Dana dolly site they provide you supplier info.

Q: 5. What thread are the posts and hardware?

A: They are 5/16-18 SS soc flat head bolts

Q: 6. can you use curved tracks on dutti dolly?

A: The Dutti dolly run on straight track only

Q: 7. Does this item(#395400) actually come with the Mitchell Riser? When I see it listed on other sites.. it does not

A: The Matthews Dutti Dolly with Mitchell Riser (Aluminum) comes with 1 x Dutti Dolly1 x Low Profile Mitchell Tie Down.

Q: 8. Can this be used with an Sachtler Aktiv8 75mm fluid head in the under slung configuration?

A: We have not had the ability to test this set up ourselves therefore we are hesitant to recommend the Aktiv8 in an underslung position. The quick release mechanism that enables the Aktiv8 head to quickly mount/dismount has not been tested or rated for inverted scenarios. We recommend using a conventional 75mm head ( such as the FSB8) if you plan to use it in an inverted position.

Q: 9. How does this compare with other similar dollys such as Dana Dolly and ProAim Polaris?

A: The main difference between the Matthews Dutti Dolly (Black, 20 x 24") and the other two dollys is that the Matthews Dutti Dolly (Black, 20 x 24") comes with wheels that allow it to roll on the floor as well as on a track. Other than that all three dollys are very similar in form and function.

Q: 10. Can this work without the need for tracks (assuming we are on a smooth surface like an indoor basketball court)?

A: We're afraid not, this dolly will require tracks. Instead we recommend the MYT Works Rover Dolly, which can be used without tracks, you will just need to add a 75mm Bowl to connect a head to it. https://bhpho.to/2Mxw5QB https://bhpho.to/31V7pVK