The brown Single Earset Mic for Select Audio-Technica Systems from Microphone Madness is an ultralow-profile, single-earloop microphone with high gain before feedback designed to deliver detail and clarity even in noisy spaces or near loudspeakers. The flexible earloop comfortably conforms to your ear and the boom can be precisely placed to deliver accurate sound. This mic is intended for voice reinforcement in theater plays, speeches, lectures, male and female vocals, and more.

Hirose 4-Pin Connector    For Audio-Technica Wireless Systems    Miniature Low-Profile Single-Ear Design    Flexible Earloop    Sturdy Boom    Hypercardioid Polar Pattern    50 Hz to 15 kHz Frequency Response    High Gain Before Feedback    For Speech & Vocals    Windscreen & Holding Clip Included

Hirose 4-pin connector for compatibility with the following Audio-Technica wireless systems: ATW-T1801, ATW-T27, ATW-T31, ATW-T51, ATW-T201, ATW-T210, ATW-T210a, ATW-T310, ATW-T310b, 200 Series, 1100 Series, 1400 Series, 1800 Series, 2000 Series, 2000a Series, 3000 Series, and 3000a Series

Related Questions and Answers

Q: 1. Does it have auto return and shut off?

A: 1. When you press the tonearm lift button, the tonearm rises from the tonearm rest. 2. Position the tonearm over the desired location (groove) on the record. 3. Press the tonearm lift button. • When you press the tonearm lift button, the tonearm descends slowly onto the record and play begins Stopping the record Once the record has played to the end, the tonearm will automatically return to the tonearm rest. To manually stop the record, do the following. 1. Lower the volume of the amplifier, speakers, etc. sufficiently. 2. Press the STOP button. • Once the record stops playing, the tonearm automatically returns to the tonearm rest. 3. Remove the record after the platter has come to a complete stop. • When the tonearm reaches the end (center) of the record, it will automatically lift and return to the tonearm rest. Do not interfere with its motion. Doing so can cause the product to malfunction. If the tonearm does not lift and return to the tonearm rest, press the STOP button to complete this operation. • If the felt mat gets dirty, it can easily scratch the record, so remove the felt mat periodically and wipe off any dust. • To prevent the record from scratches and warping, remove it after use. • Do not use a disk stabilizer. • Do not use a platter other than the one provided. • This product is not intended for DJs. Do not touch the record or the platter while the record is playing.

Q: 2. What is the difference between the B and the R models?

A: AT 831b POLAR PATTERNCardioidFREQUENCY RESPONSE40-18,000 HzLOW FREQUENCY ROLL-OFF80 Hz, 18 dB/octaveOPEN CIRCUIT SENSITIVITY Phantom: -44 dB (6.3 mV) re 1V at 1 Pa Battery: -46 dB (5.0 mV) re 1V at 1 PaIMPEDANCEPhantom: 200 ohms Battery: 270 ohmsAT831rPOLAR PATTERNCardioidFREQUENCY RESPONSE40-16,000 HzLOW FREQUENCY ROLL-OFF80 Hz, 18 dB/octaveOPEN CIRCUIT SENSITIVITY Phantom: -44 dB (6.3 mV) re 1V at 1 Pa IMPEDANCEPhantom: 200 ohms Mainly the b has two power sources - battery and phantom power plus a wider freq response, but a shorter cable.

Q: 3. Could I use the phono pre-amp to plug bookshelf speakers such as the Sony SS-CS5 directly to the turntable, or would I need an additional receiver?

A: Passive bookshelf speakers like the Sony SS-CS5 3-Way Bookshelf Speaker (Pair) BH #SOSSCS5 require power from an AV receiver or amplifier. They cannot be connected directly to this or any other similar turntable.

Q: 4. Will the AT875R work on a Panasonic Lumix GH4? Does it plug directly in or do I need a pre amp?

A: The Audio-Technica AT875R Short Shotgun Microphone requires phantom power to operate, which is not provided directly from the 3.5mm external microphone input on the Panasonic Lumix GH4 Mirrorless Camera. To use these two components together, a device that provides a phantom-powered XLR input preamp and converts the signal to a 3.5mm microphone output is required. BH #BEDXAMICROP Beachtek DXA-MICRO-PRO Active XLR Compact Adapter is a good solution in this scenario: https://bhpho.to/3tzeD2N

Q: 5. I would like to connect AT875R to Line input in Canon 1Dx II camera, have I to add a phantom power module to run mic, and wich works properly? thanks

A: Yes you need Phantom power

Q: 6. Does it include cartridge?

A: Included In the Box would be the following. Audio-Technica Consumer AT-LP60X Stereo Turntable (Black) 45 rpm Adapter 1/8" to Stereo RCA Cable Hinged Dust Cover AC Adapter Limited 1-Year Warranty

Q: 7. What is the Optimal Pickup Range? looking to use it for interviews on set. I would have it over the talents head, out of frame

A: You should be able to place the Audio-Technica AT875R Short Shotgun Microphone about 3 to 5 feet overhead to capture clear audio, then adjust the distance to find the sweet spot, depending on how loud the people are speaking.

Q: 8. Are there speaker built in or do need to purchase separate to hear

A: The LP60 unfortunately does not have any internal speakers. You will need to connect the unit to a speaker system.

Q: 9. attaching this to the Canon XA10 what cable do i need to purchase? Thanks!

A: If you are interested in mounting the 875R to the XA10, we recommend a short XLR cable. Kopul makes a variety of high quality cables. The 4000 is a premium cable and comes in coiled or straight.

Q: 10. Does this come with a mic holder if I'm not using it with a shock mount?

A: Yes it does!