The graphite, 8.8L 908 Hard Case from Nanuk is made from crush, dust, and waterproof lightweight NK-7 polypropylene resin. It protects and stores delicate small- and medium-sized items like photo/video gear, batteries, lenses, flash drives, hard drives, microphone systems, pistols, fishing gear, binoculars, scopes, medical devices, instrumentation, industrial tools, or other personal and professional equipment. This version of the 908 is offered without an insert, leaving the entire 9.5 x 7.5 x 7.5" interior available for complete customization for your specific gear.

Its molded-in bezel and gasket are held fast with the PowerClaw latching system. This patented latch uses compressive force to tightly clamp the case shut to a waterproof and dustproof IP67 rating, with an integrated slide lock that prevents the case from opening during transport or if dropped. For additional security, there are two 0.34" padlock holes integrated into the case and lid. The case features a built-in pressure relief valve that regulates the internal pressure, keeping your gear and the case from getting crushed during air travel and allowing you to open the case without having to break a tough pressurized seal that may develop. Further design features include an integrated lid stay that prevents the lid from closing on your hand, rustproof and strong stainless steel hardware, and a foldable soft-grip handle at the top. This case can be stacked with other Nanuk 908 cases for your convenience.

Crush, Dust, and Waterproof    Padded Insert with Convoluted Lid Foam    Dividers to Organize & Protect Gear    Lightweight NK-7 Polypropylene Resin    2 PowerClaw Latches    Automatic Pressure Release Valve    Molded-In Bezel System and Padlock Holes    Comfortable Soft-Grip Handle

Related Questions and Answers

Q: 1. Can this fir the Sirui Night Walker cine lenses?

A: Yes, the Nanuk 918 Hard Case with Foam Insert for Six Lenses (Black, 20.L) will fit the Sirui Night Walker Cine Lens series. The lens dimensions are 79mm wide, and 85.4mm tall. The lenses inserts on the pre cut foam that comes with the case are 103mm wide by 113mm long.

Q: 2. Can the Meike ff cine prime lenses PL mount fit in ?

A: Yes, the Meike Full-Frame Cine Prime PL-mount lenses will fit in the Nanuk 918 6-Lens Case with Foam Insert (Black).

Q: 3. Has anyone tried adapting trekpak inserts to fit this case (or other Nanuk cases?)

A: for this case I would suggest a Nanuk Padded Divider Insert for 915 Case B&H # NA915DIVI as it is made for this case.

Q: 4. Can you tell me if this will hold a set of Rokinon Cine DS lenses? ( 16, 24, 35, 50, 85, 135mm).

A: Yes this case can hold those Rokinon lenses.

Q: 5. Would the Canon EF 70-200 f/2.8 fit there? Its length is 8.5 inches, but I read that 24-105 f/4 would be the largest, which is much smaller ...

A: The Canon EF 70-200mm f/2.8L IS USM lens would be just a bit too long to fit this case.

Q: 6. How deep is the 4" section of the hole? Is the lower section exactly 3"? Would a 3.15" lens be able to squeeze in?

A: The pre-cut foam dimensions included with Nanuk 918 6-Lens Case are 6.5 x 9 x 10.5 inches. each lens cavity has 2 removable foam disc to fit long or short lenses. The first session is 2 inches deep. the first foam disc is 1.5'' tall and the second disk towards the bottom of the insert is 2.5 inchees tall. If you remove all foam disk the insert would reach a 6 inche depth. The width of the insert on the top section is 4 inchess, the botton sections is only 3 inches. I wouldnt't recommend this inserts if your lens circumference is winder then the insert because of the pressure you'll be putting on your lenses.

Q: 7. Can you tell me if this will hold a set of DZO Vespid prime ?

A: We recommend the following case for Vespid lenses. https://bhpho.to/3zLO0aL

Q: 8. Is this case going to accommodate DZO Arles lenses?

A: The Nanuk 918 Hard Case with Foam Insert for Six Lenses (Yellow, 21L) would not be a good choice for the DZOFilm Arles lenses. The DZOFilm Hard Case for Arles 5-Lens Set, BH #DZOCASEAP5, would be recommended to use with the Arles series of lenses.

Q: 9. Would Zeiss CP.3 lenses fit in here?

A: Yes. While they may be slightly snug, the ZEISS Compact Prime CP.3 Lenses should fit inside the Nanuk 918 6-Lens Case with Foam Insert.

Q: 10. Are the Nanuk first aid cases FSA eligible?

A: The certifications of the Nanuk 915 Hard Case First-Aid Kit (Red): MIL-STD-810F Immersion ASTM D-4169 DC-18 Rainfall ASTM D-4169 DC-18 Vibration ASTM D-4169 DC-18 Drop Test ATA Specification 300 - Category 1 Impact IP6X Ingress Protection - Dustproof IPX7 Ingress Protection - Waterproof