Ideal for reinforcing components to a rigging structure, the 5/8" Closed Gag from 9.Solutions allows the option of joining a 5/8" diameter rod with a 3/8" rod or another 5/8" rod and permits positioning of them within a 360-degree range.

Joins Two 5/8" Rods    Option of Joining a 5/8" Rod & 3/8" Rod    Allows 360° Positioning

Related Questions and Answers

Q: 1. Need ultra-light head (for travel) to grip 5/8" foamcore fork on stand. Is this strong enough to position a 4x4' board?

A: Yes, as long as you will be positioning the Foamcore in an upright position it will hold. If you will be positioning the Foamcore in a position that puts more stress on the lock like in a horizontal position it may not hold as well. It will all depend on how it is used. Another option I could suggest to you would be the Matthews Mini Grip Head. BH #MAMGH For full control of the Foamcore you may need to get a normal sized grip head.

Q: 2. Specs say the length of this thing is 4.75 inches?! That cannot be right. Perhaps each section is 4.75 inches? Can anyone confirm the actual dimensions of this thing?

A: The total length of the arm is 18.7 inches.

Q: 3. How is the rod locked into place?

A: You use the knob to tighten the clamp.

Q: 4. What is the thickest tablet this holder can accommodate?

A: There is no limit on thickness, just width. The device uses a spring-loaded jaw that opens between 5.2" and 8.9" wide.

Q: 5. Can the head be rotated?

A: The head of the clamp can be rotated.

Q: 6. will this hold a 5/8 baby pin?

A: Yes, you can insert a 5/8" baby pin into the Kupo Gag Grip Head (Black).

Q: 7. Can the monitor be mounted vertically?

A: Yes it can be mounted vertically.

Q: 8. What is the pull rating of this vacuum mount?

A: The information listed for the 9.SOLUTIONS Suction Cup is maximum load from the base. And that is, 4.4 lbs.

Q: 9. Will the phone clamp fit an iphoneXS MAx with a Spigen toughcase on it?

A: The Spigen Tough Case for the iPhone XS Max, is 3.26" wide, making it too large to fit properly in this phone clamp. The maximum width is 3.1".

Q: 10. 1/4 to 1/4?

A: The 9.SOLUTIONS Reversal Adapter has 3/8"-16 and 1/4"-20 screws; it also has 3/8"-16 and 1/4"-20 threads.