You are using an outdated browser. For a faster, safer browsing experience, upgrade for free today.
Phones: 800
$ USD
  • Your shopping cart is empty!

Camplex 4-channel Opticalcon Quad Lite Multi-mode Fiber Tactical Cable Reel (500')

Camplex 4-channel Opticalcon Quad Lite Multi-mode Fiber Tactical Cable Reel (500')
  • Product Code: ga46066
  • Availability: In Stock

$2,330.85 $3,239.88

Neutrik opticalCON LITE QUAD Multimode fiber reels by Camplex provide a semi-rugged alternative to opticalCON Advanced systems when the action calls for a compact, lightweight solution. The cable is designed to allow higher bend radius performance typically used in rack interconnects, camera cranes, steadicam rigs, truck bays and other similarly controlled environments. Best of all, It is fully compatible with standard opticalCON QUAD connections.
The QUAD delivers a ruggedized 4-channel fiber optic connection system for semi and permanent installation. Mated connections are waterproof acc. to IP65 safety standards and the reliable push-pull locking mechanism assures there is never an accidental disconnect. All connections are compatible with standard opticalCON QUAD NO4FDW-A chassis connectors.

Key Specs
Cable Length498.7' / 152 m
Fiber TypeOM3 Multimode
General
Coupling TypeOpticalCON QUAD
Cable Length498.7' / 152 m
Fiber TypeOM3 Multimode
Physical and Environmental
Environmental ProtectionDust/Water-Resistant (IP65)

  • 4-channel multimode tactical patch cable
  • Rugged lightweight reel with brake lock
  • Dust and waterproof according to IP65 in mated condition
  • Bend optimized OM3 fiber
  • Rugged push-pull locking mechanism with rubber caps
  • Lifetime 2500 mating cycles
  • Easy to clean shutterless connectors
  • Rugged cable retention utilizing aramid yarn strength member
  • Extremely flexible and crush resistant
  • Lightweight plastic housing

Related Questions and Answers

Q: 1. Is it necessary to fill up the whole tank with chemicals even if you're developing only 1 or 2 rolls ? I understand that empty reels should still be stacked up to prevent the loaded reel to move too much but still need to be sure if the less than full tank affects developing in a bad way ?

A: No it's not, below the tank you can find the specific volume for each number or reels either 120 or 35mm, just make sure as you said the empty reels are stacked above to prevent it does not get chemicals.

Q: 2. Will the catlabs 8x10 reel work in this tank?

A: No, the CatLABS CL81: an 8X10 Sheet Film Processing Reel is made specific for the Jobo MultiTank 5. Not the Paterson Super System 4 Multi-Reel 8 Developing Tank. This is the link to the Jobo 2550 Multi Tank 5 (640mL), https://bhpho.to/3plCZu0 .

Q: 3. How many ounces does this hold when full?

A: The tank requires 10oz (290ml) per 35mm roll of film. The tank can hold 5 rolls of 35mm film so it would require 50oz (1,450ml). The tank can also hold 3 rolls of 120/220 film that requires 17oz (500ml) per roll, so that is 51oz (1,500ml) for 3 rolls of 120/220 film.

Q: 4. How many ounces does this hold with 2 reels?

A: The tank holds 33.8oz (1L) with room or a bit more. 35mm x2: 20oz120 x2: 35oz

Q: 5. how long does it take to fill up the entire tank with chemistry? i believe 5rolls of 135 would require 1500ml of it. do you need to compensate for time to avoid over develop negatives in the bottom?

A: It's only a matter of 10-15 seconds. I compensate about 5 seconds and have never had issues! I've never directly measured how much chemistry, but use a 2L kit and life is easy. I would guess its more around 1600ml!!

Q: 6. Can you use two MOD54's in this tank?

A: Yes, you could fit two MOD54s in the Multi Reel 8 tank.

Q: 7. what's difference between this and Paterson 4 x 5 Sheet Film Developing Tank with Reel?

A: Thus reply may not be helpful, but I will try -- Paterson tanks have interchangable parts. Between the parts you will need to buy and those you may already have, for 4x5 you will need a tall tank, a long center tube, and a 4x5 holder. The holder looks vaguely like a dragon and holds up to 6 sheets. I have loaded mine with up to 4 sheets in a changing bag. The tank holds twice the developer of a short tank (which is for one 120 roll of film.) If you have two 120 spools, you can develop two 120 rolls. instead of the 4x5 sheets.Other parts: a funnel to make the tank light tight, a tank top to keep the fluids in place, and a twist part to allow agitation. These are the same for small or large tanks and come with the tank.l

Q: 8. Will it accept the Nikkor/Honeywell stainless steel film reels ?

A: No, stainless steel developing reels are not compatible with this tank.

Q: 9. Does this tank come with an inner rod to hold the reels and a spindle to turn the reels?

A: Yes. In the Box: Paterson Multi-Reel 3 Developing Tank Paterson Center Column and Agitator Kit for Multi-Reel 3 Tank Paterson Funnel and Lid Kit Agitator Rod

Q: 10. Does this kit come with any reels, or must they be purchased separately?

A: You have to purchase separately.

There are no reviews for this product.

Write a review

Note: HTML is not translated!
    Bad           Good
Captcha

Top Bestselling Products

Products You May Like

Milestone Husky Ivo 150d With 4tb Hdd

$7,425.00 $8,910.00

Jason Cases Zeiss Super Speeds 5-lens Case

$1,497.00 $1,991.01

Heliopan 107mm Clear Protection Filter

$644.85 $889.89

Christie Touch Overlay For 75" Uhd751-p

$3,087.00 $4,939.20