A useful, rugged aluminum accessory that organizes overhead dangling cables, the Drop Ceiling Scissor Clamp with Cable Support from Impact connects to the support rails of most drop ceilings and suspends them overhead and out of the way via an integrated hook. The cables are constantly in view to facilitate swapping out.

Attaches to Drop Ceilings    Supports and Organizes Dangling Cables    Aluminum Construction

The clamp attaches to the support grid rails of most drop ceilings and prevents dangling cables by suspending them overhead, keeping them off the floor but still visible for easy swapping out.

Aluminum construction provides the strength to support multiple cables.

Related Questions and Answers

Q: 1. Is this mount compatiable with Marshall Electronics CV355-30X-IP Full HD IP Zoom Camera? If not, can you recommend a mount that will work with drop ceiling?

A: The ALZO Suspended Drop Ceiling Upright Camera Mount will have a 1/4-20"mount available for attaching the Marshall Electronics CV355-30X-IP Full HD IP Zoom Camera.

Q: 2. Will this mount fit a Sony NX5R Camcorder?

A: TheSony HXR-NX5R NXCAM Professional Camcorder with Built-In LED Light will not fit the ALZO Suspended Drop Ceiling Upright Camera Mount as you only have space for a 5.5" for camera and the HXR-NX5R surpasses this measurement.

Q: 3. How many inches does this hang down from the ceiling?

A: Being that the stud of the Dedolight Scissor Clamp with 5/8" Stud (B&H# DECLAMPS) is 6.25" (15.7cm) long, the end of the stud will be a little over 6" (15cm) below the height of the ceiling when installed.

Q: 4. How much weight can it hold?

A: This scissor clamp would be limited by how well the ceiling was anchored and supported.

Q: 5. How small can the pantograph collapse?

A: This Impact wall mount boom closes to about 9.5 inches from the wall.

Q: 6. Hi, I assume the threads on the pin to be 1/4 ? ... and if so, is the pin male or female?

A: The threads on the pin is a 1/4 Male, easy to go with a baby pin female.

Q: 7. what is the baring weight of these hooks, could I use a pair of them to hold up a sound blanket? (12 lbs)

A: Depends on the number of hooks you use. A hook every few feet should support the sound blanket without a problem. These are normally used to rout cables along the ceiling.

Q: 8. Are there extension poles that can be attached to this to hang items lower?

A: You can attach a short c-stand arm or a magic arm with baby receiver. You must always use a safety chain when rigging from the ceiling, so make sure you have a long enough safety chain for the extension.

Q: 9. Can I attach a microphone (5/8 ) clip?

A: You probably can but it requires a few pieces of intermediate hardware: First get the Micro Clamp with Spigot Kit, then get a 3/8 female to 5/8 male adapter. Attach your 5/8 female mic clip. Voila!

Q: 10. Can the pin be removed and have just threading off the scissor clip?

A: Yes, you may unscrew the pin on the Avenger C1000 to expose the threading.