The 5-pack of 1/4"-20 D-Ring Screws are made from stainless steel and are ideal as replacement screws for quick release plates. The screw's shaft is 10mm long and can tighten down via the hinged D-ring or using a screwdriver.

Tighten with D-Ring or Screwdriver Slot    Made from Stainless Steel    10mm-Long Shaft    Ideal for Quick Release Plates

Related Questions and Answers

Q: 1. Do these screws work with the Really Right Stuff One-piece L-bracket for the Nikon Z 7?

A: Yes, the Really Right Stuff One-piece L Bracket for the Nikon Z uses standard 1/4-20 sockets, so these screws should work just fine.

Q: 2. Can this fit the Mefoto camera plates?

A: The dimensions of these screws are 0.59 x 1.06 x 1.08 (1.50 x 2.70 x 2.75 cm) You can measure the plate and hopefully the Mefoto screw to check. It seems that these might be a little large in the ring and head. Unfortunately, it is not possible for us to go to our inventory to check here at B&H. Here are all the available quick release plate screws B&H has for sale. http://bhpho.to/1UC21jQ

Q: 3. Will it fit the sony fs7?

A: If you were to use it in lieu of its own handle, then you can find a way to mount it, but if the FS7 has its own handle on, there really would be no dynamic configuration that would make this work.

Q: 4. will this attach to a SmallHD 702 touch?

A: Yes, the SmallRig Swivel and Tilt Monitor Mount with 2 x 1/4"-20 Screws will mount to the SmallHD 702 Touch 7" On-Camera Monitor.

Q: 5. Gives the depth of the screw but does not give the diameter of the head. What is the diameter of the head?

A: The head diameter of the head with D ring is 5/8".

Q: 6. is the rubber grip removable?

A: It is not designed to be removable or replaceable.

Q: 7. What is the length of these screws?

A: Ikan lists the dimensions of the ikan 3/8"-16 D-Ring Screws as 0.59 x 1.06 x 1.08"

Q: 8. Is there anything that can mount in the front of the handle if you remove the plug?

A: The SmallRig Top Handle with Rubber Grip has 1/4 20 screw connections and a shoe mount on the front of the handle that would allow you to mount gear.

Q: 9. Will this mount clear the GoPro Hero 9 or later?

A: Yes. The 9.SOLUTIONS GoPro Thumb Screws will work for GoPro Hero 9 and later.

Q: 10. Is the cold shoe standard sized? Can i attach a regular LED light or DSLR mic in it?

A: Yes, it is a standard cold shoe size. It may be a bit shorter than ones you'd find on a camera, but the width is the same and works very well.