The CAMVATE Single 15mm Rod Clamp with 1/4"-20 Threads, with a black ratcheting knob, offers two 1/4"-20 threaded holes for attaching accessories to your rig. Choose to use either hole depending on which side you want to mount to. The ratcheting knob is spring-loaded so you can adjust it not to interfere with other gear on your rig.

Two 1/4"-20 Threaded Accessory Holes    Spring-Loaded Ratcheting Knob

Related Questions and Answers

Q: 1. Will this fit the Tilta Advanced Ring for the RS2?

A: Yes, the CAMVATE Super Crab Clamp will fit the Tilta Advanced Ring Grip.

Q: 2. Are the rail holes 60mm apart?

A: Yes they are. This is a standard 15mm rod support system, which has 60mm spacing between the rods.

Q: 3. Can you remove the screw that holds the thumbscrew, leaving another threaded 1/4"-20 hole on the clamp, or is the screw permanently attached to the clamp?

A: The thumbscrew is required to tighten the rod clamp on the 15mm rod. In addition to that the screw for holding the thumbscrew is smaller than a 1/4 20

Q: 4. Would this work to add a single rod onto a cage?

A: Yes it can do that.

Q: 5. Can the cold shoe be rotated 90 degrees?

A: There is a screw holding the shoe onto the CAMVATE 15mm Single Rod Clamp with Cold Shoe Mount Adapter (Black Locking Lever) that can be removed but the machining may not allow it to fit in another direction.

Q: 6. specs? HOW MUCH rise?

A: This product has a rise of 30mm or 1.18 inches.

Q: 7. Does the locating pin prevent this from fitting in one of the 3/8"-16 slots on the 8Sinn pro top handle - https://www.bhphotovideo.com/c/product/1382435-REG/8sinn_8_thp_top_handle_pro.html?

A: It depends how you mount it. The pin is removable if needed.

Q: 8. Is the thread 3/8 Whitworth? I'm hoping it's the same threading on the top of a boom pole. Thanks.

A: The 3/8"-16 end is the same as boom poles with 3/8"-16 ends. A boom pole's 3/8"-16 screw will not screw into the CAMVATE 3/8"-16 Mount To 15mm Single Rod Clamp. Any 3/8"-16 female coupler will connect the two items together.

Q: 9. How may I buy just the rubber friction wheel and will that fit over similar gears from other manufacturers?

A: The SHAPE Follow Focus Kit with Single 15mm Rod Clamp could work with the following seamless rings. Seamless Rings: https://bit.ly/3MD9AXN How to check what rings work with your lenses: https://bit.ly/49uzp62

Q: 10. Does this have adjustable hard stops?

A: It does not.