Remotely control and trigger a variety of flashes and radio receivers all from the YN560-TX II Manual Flash Controller from Yongnuo. Designed to work with Nikon cameras, this transmitter is compatible with a variety of equipment, including YN560 III, YN560 IV, YN660, YN968, and YN860Li Speedlites and the RF602, RF603, RF603 II, and RF605 transceivers. This updated model is equipped with a redesigned LCD menu and a quick-locking foot. Using a 2.4 GHz frequency radio with a range of 328' and a choice of 16 channels, the YN560-TX II is able to reliably trigger your flashes from impressive distances. Also, it has remote power control and zoom control from 24-105mm for flashes set up within the six available groups. Additionally, it has a 2.5mm sync port and runs on two AA batteries.

Works with YN560 III and Later Flashes    Supports RF602, RF603, RF603 II, & RF605    Frequency: 2.4 GHz    Range: 328'    16 Channels and 6 Groups    Remote Power and Zoom Control    Updated LCD Layout; Quick-Locking Foot    2.5mm Sync Port    Runs on Two AA Batteries

Related Questions and Answers

Q: 1. Will this work to trigger a yongnuo yn560iii speedlight with my sony a6500?

A: While this transmitter could fit a A6500, it may work intermittently since the shoe mount is different on this camera. Your results may vary.

Q: 2. I have 4 YN560II. Would I still have the ability to adjust these flashes w/ the RF 605, or do I need to replace them with the YN 560 III or IV?

A: As per the manufacturer, this transmitter is not compatible with the YN560 II flash.

Q: 3. Would this work with old Metz+Yongnuo receiver?

A: To fire the Metz, yes. But no remote power control or zoom control.

Q: 4. Will this support the Canon 60D external flash control?

A: It works well with my Canon 750D II, looking at a light metre next

Q: 5. Can i use this with film cameras? If not! Any suggestions?

A: Yes , this can be used with film cameras

Q: 6. If the YN560-TX II is used in conjunction with the RF-603 II, can I use the remote power/zoom control or will it only trigger the flash? The flash is a Polaroid PL-190N.

A: With the setup you describe, the YN560-TX II will only act as a trigger.

Q: 7. Will this version of the trigger awaken a sleeping 560 IV?

A: Yes.. you can wake from SE by using the group* button on the top left. Works with Iv and III models.

Q: 8. Will this work with Canon Rebel SL2?

A: This will work with a SL2.

Q: 9. Can this be used to trigger two Yongnuo YN560-IV manual Speedlites? planning to use canon80d

A: Yes, You can use several YN560-IV or III on the sema group or in diferents groups with diferent power and mode(Manual or multiple) in each group. Best regards

Q: 10. I have a Nikon 810 using the remote Yongnuo RF605n on SB800 Speedlight, Can I use the YN560-TX II to fire these units, can I set them from the camera?

A: Yes the YN560TX II can fire the Yongnuo RF605N attached to a Nikon speed light like the SB-800.