Ultra-thin and flexible, this 3.3' Mini BNC to BNC SDI Cable from CAMVATE is designed for use with select video assist monitors. One end plugs into your camera's SDI video output port and the other end connects to your monitor's SDI input port.

For Select Video Assist Monitors    Mini BNC to Micro BNC Cable    Ultra-Thin, Flexible Cable    3.3' Cable

Select video assist monitors.

Ultra-thin and flexible cable is easy to dress on your camera rig.

Related Questions and Answers

Q: 1. Is this compatible with the 4K output from the Blackmagic Design 4K Studio Camera?

A: This cable will be fine with that camera.

Q: 2. How long is this cable?

A: The cable length is 420mm / 16in.

Q: 3. Looking to use this with my Komodo and red recommends a 12g sdi cable. Does this qualify?

A: If your use is to use this for an EVF or on-camera monitor which uses SDI, this will work.

Q: 4. Is this compatible with 12G-SDI?

A: While is of course depends what devices you are using and what is being transmitted, this short length it should do 12G-SDI without issue.

Q: 5. Is this the correct cable for jam syncing timecode with the Zoom F8?

A: If that requires a standard BNC cable, then yes.

Q: 6. would this work to jam sync between a timecode solutions UltraSync one and a dji osmo Pocket 3?

A: Theoretically, you can use the Sound Devices BNC to USB-C Timecode Cable for A20-Mini to jam sync the Atomos UltraSync ONE RF Timecode Sync for AtomX Sync and Ninja V with the DJI Osmo Pocket 3. However, according to DJI, they have not specifically tested if timecode via BNC will pass through the USB-C port of the Osmo Pocket 3.

Q: 7. Would this cable work to jam sync TC between a MixPre10-II and a MixPre6-II?

A: Neither the MixPre6-II nor the MixPre10-II support timecode over USB-C, so the Sound Devices BNC to USB-C Timecode Cable for A20-Mini would not be appropriate for connecting the two devices.

Q: 8. I'm looking for the cable to send timecode from my mixture to an arri camera is this the one

A: That depends on the Mixer and the specific Arri camera that you plan to work with. if your Mixer has a BNC Timecode output and you plan to use it with one of the Arri Alexa Mini cameras then this cable will work.

Q: 9. Can it work to connect the new pyxis to the video assist 5” 3g? And is this made by blackmagic?

A: Yes, in order to connect the Blackmagic Design PYXIS 6K Cinema Box Camera to any models of the Blackmagic Design Video Assist recording monitors the Blackmagic Design Micro BNC to BNC Male Cable for Video Assist will indeed be needed.

Q: 10. Can this be used with the PSC RF Splitter?

A: The PSC RF Splitter is designed for antenna distrobution. This is not an antenna wire.