Ultra-thin and flexible, this 6.6' Mini BNC to BNC SDI Cable from CAMVATE is designed for use with select video assist monitors. One end plugs into your camera's SDI video output port and the other end connects to your monitor's SDI input port.

For Select Video Assist Monitors    Mini BNC to Micro BNC Cable    Ultra-Thin, Flexible Cable    6.6' Cable

Select video assist monitors.

Ultra-thin and flexible cable is easy to dress on your camera rig.

Related Questions and Answers

Q: 1. would this work to jam sync between a timecode solutions UltraSync one and a dji osmo Pocket 3?

A: Theoretically, you can use the Sound Devices BNC to USB-C Timecode Cable for A20-Mini to jam sync the Atomos UltraSync ONE RF Timecode Sync for AtomX Sync and Ninja V with the DJI Osmo Pocket 3. However, according to DJI, they have not specifically tested if timecode via BNC will pass through the USB-C port of the Osmo Pocket 3.

Q: 2. Would this be good for an outdoor application such as a camera for live video at a football game?

A: Yes this is a good cable.

Q: 3. Is this rated at 12G?

A: Yes, this cable is 12G rated.

Q: 4. 1` long enough to reach the SDI port on the Komodo Camera, from a monitor mounted on top of a "top" handle?

A: 1' cables like the ShieldRock 12G-SDI BNC to BNC 4K UHD Cable (1') would likely be a little to short to work well in such a setup. A 1.5' cable or longer would be a better fit.

Q: 5. How long is this cable?

A: The cable length is 420mm / 16in.

Q: 6. How do you disconnect

A: To disconnect the Blackmagic Design Micro BNC to BNC Male Cable for Video Assist (27.6"), you'll need to twist and pull the BNC connector.

Q: 7. Can this be used with the PSC RF Splitter?

A: The PSC RF Splitter is designed for antenna distrobution. This is not an antenna wire.

Q: 8. Is this compatible with 12G-SDI?

A: While is of course depends what devices you are using and what is being transmitted, this short length it should do 12G-SDI without issue.

Q: 9. Would this cable work to jam sync TC between a MixPre10-II and a MixPre6-II?

A: Neither the MixPre6-II nor the MixPre10-II support timecode over USB-C, so the Sound Devices BNC to USB-C Timecode Cable for A20-Mini would not be appropriate for connecting the two devices.

Q: 10. Would this work between the RODE Wireless Pro Receiver and an FX6 BNC port?

A: The Sound Devices BNC to USB-C Timecode Cable for A20-Mini has not been tested with the Rode Wireless Pro, so unfortunately compatibility cannot be guaranteed.