This Go Professional Cases Hard Case for DJI Inspire 2 is a custom rolling hard case for your DJI Inspire 2 in "travel mode" with a Zenmuse X4, X5S, or X7 gimbal camera. While travel mode is not as quick as landing mode, in terms of setup, it is better suited to situations with checked luggage. The case also accommodates other essentials with slots for Cendence controllers, CrystalSky monitors, batteries, chargers, recording media, and more. The case itself is made from a durable polypropylene copolymer resin, and is gasket sealed to protect against moisture and dust ingress.

Holds Inspire 2 in Travel Mode    Holds Zenmuse X4/X5S/X7 Gimbal Camera    Holds up to 8 Flight Batteries    Holds 2 CrystalSky Monitors or iPads    Holds Remote Controller and Cendence    Holds a Charging Hub    Hold Four SSDs and CineSSD Station    Holds a Set of Spare Propellers    Cavities for Miscellaneous Accessories

Waterjet precision-cut with closed-cell foam to resist water and dust infiltration

Custom foam is housed in a durable SKB case

Wheels for easy transport

Padlock holes include stainless steel padlock-protector clips

Waterproof and dust-tight design

Molded-in hinge for added protection

Built-in pull-handle with one-finger lock release

Trigger-release latch system

Snap-down rubber over-molded cushion grip handle

Ambient pressure equalization valve

Resistant to UV, solvents, corrosion, fungus

Resistant to impact damage

Related Questions and Answers

Q: 1. Can it fit a crystal sky?

A: The CasePro Landing Mode Wheeled Hard-Shell Case for DJI Inspire 2 will not have a designated compartment for the Crystal Sky Monitors. The following compartments are available in the case: 1x Inspire 2 drone 2 x Inspire 2 transmitters 2 x iPads (Up to 9") Zenmuse X4S or X5S Gimbal Camera (on or off the drone) 12 x Inspire 2 batteries 5 x Cine SSD cards SSD card reader 3 x Charging Hubs Extra propellers Battery charger and cables Inspire 2 camera box DJI Follow Focus CasePro tool case Other accessories via 4 additional compartments

Q: 2. Does this case have a little net pouch under the lid to store licenses etc?

A: Unfortunately, this product does not have a net pouch under the lid.

Q: 3. Does the Cendence remote with Patch Antenna fit in this case?

A: Yes - perfectly

Q: 4. Does this hold the X7 still attached?

A: Yes, it does. If a lens is attached, the gimbal should be rotated so the lens points to the aft end of the aircraft. The gimbal and lens are not cushioned by foam in that position, but careful personal transport over short distances should be OK, in my opinion. A rep from the manufacturer concurred, but she said they recommend removing the gimbal when shipping the case.

Q: 5. Looking for a hard case with wheel that will fit the Phantom 3 kit with the prop guards. Question, will the drone fit in this case with the guard props on (without taking it off from the drone)?

A: no

Q: 6. Will an iPad Pro 10.5 fit in one of the slots designated for CrystalSky/iPad?

A: It can be fitted there .... there are different slots for ipad and crystal sky

Q: 7. How far away from each controller can operators be?

A: Maximum Communication Distance: 2.4 GHz: 492' / 150.0 m 5.8 GHz: 328' / 100.0 m

Q: 8. Does it fit the I2 with X7 attached ?

A: I leave my camera attached. I have the 4 though. I am sure it would as long as the lens was not attached.

Q: 9. How many batteries total will this travel mode case hold?

A: This Travel Mode case model can hold up to 8 Flight Batteries.

Q: 10. Will this case work with the Inspire 1 v 2.0 ?

A: No it will not.