Hide your cable box, satellite receiver, security NVR, or other device behind your wall-mounted monitor with the black Adjustable Wall Mount for Large, Slim Device from HIDEit Mounts. Its depth-adjustable design enables you to switch the mount between compatible devices without hassle. The mount allows easy access to your device's buttons, ports, and cords.

Wall-Mounts Device Behind Monitor    Depth Adjustable from 1.5 to 2.75"    Easy to Switch Between Devices    Easy Access to Buttons and Cables    16-Gauge Steel Construction    Powder Coat Finish    Simple Installation    Mounting Hardware Included

Depth adjustable from 1.5 to 2.75" to fit a wide range of components

Easy access to power button, output jacks, and cables on either side

Cold-rolled 16-gauge steel for strength

Powder coat finish protects from scratches

Quick and easy to assemble and install with no measuring or templates

Includes drywall screws, anchors rated for 25 lb each, and wing/thumbnuts (stud mounting is not necessary)

Made in the USA from recycled and imported steel

Related Questions and Answers

Q: 1. Can the camera be mounted at 90 degrees?

A: I see no reason why it would not work. You will need to design mount for the PTZOptics Large Universal Rounded Nose Wall Mount to attach to so that the camera is positioned at 90 deg. The mount is designed to support wall mounting where the top of the camera is facing vertically up or down. If you want the camera top in a horizontal position you would need to design a wood block extension to attach the mount to.

Q: 2. What dimensions (in mm) are the rear mounting holes arranged in?

A: The dimensions and positions of the mounting holes are not listed by Huddlecam at this time. However if you email us at askbh@bhphoto.com we can guide you towards additional literature for this product that may help.

Q: 3. Can I mount this on a 23 degree ceiling, meaning the mount and rod would be at an angle rather than straight down?

A: The Pyle Pro Swivel/Adjustable Wall/Ceiling Speaker Mounts (Pair), BH # PYPSTNDC31, may be mounted on an angled ceiling.

Q: 4. What is the height between the base and the utility shelf? I need at least 22" clearance.

A: The shelf clearance is 21".

Q: 5. What is the outside diameter of the top most column? Is it 35mm (1.375 in.) like a Pyle Pro speaker stand?

A: Unfortunately there is no information on the diameter of the top telescope section of the stand.

Q: 6. It says on the Hive site that this large (8") Fresnel will fit the Profoto B10. Is that true?

A: Yes 100%. The following system will mount to a Profoto B10.

Q: 7. Can SVS Prime elevation speaker mount be used with this?

A: The Pyle Pro Swivel/Adjustable Wall/Ceiling Speaker Mounts will support the weight of the SVS Prime Elevation Speakers, but we are not able to confirm whether the holes on the mounting bracket that is included with the SVS speakers will line up properly with the holes on the plate for the Pyle Pro Speaker Mounts.

Q: 8. What is the radius of the three legs?

A: It is adjustable. Maximum extension from center vertical pole to end of leg is radius about 10.5 Mine is quite sturdy even adjusted to 9.5 radius.

Q: 9. Was is maximum extended height?

A: About 24 inches

Q: 10. I'm assuming there's only one mount in the box, so I need to buy two boxes to mount the pair of speakers I have. Correct?

A: Yes. If you want to mount 2 speakers, then you would need 1 mount for each speaker.