Hide your cable box, satellite receiver, DVR, security NVR, or other device behind your wall-mounted monitor with the black Adjustable Wall Mount for Large Device from HIDEit Mounts. Its depth-adjustable design enables you to switch the mount between compatible devices without hassle. The mount allows easy access to your device's buttons, ports, and cords.

Wall-Mounts Device Behind Monitor    Depth Adjustable from 2.66 to 3.75"    Easy to Switch Between Devices    Easy Access to Buttons and Cables    16-Gauge Steel Construction    Powder Coat Finish    Simple Installation    Mounting Hardware Included

Depth adjustable from 2.66 to 3.75" to fit a wide range of components

Easy access to power button, output jacks, and cables on either side

Cold-rolled 16-gauge steel for strength

Powder coat finish protects from scratches

Quick and easy to assemble and install with no measuring or templates

Includes drywall screws, anchors rated for 25 lb each, and wing/thumbnuts (stud mounting is not necessary)

Made in the USA from recycled and imported steel

Related Questions and Answers

Q: 1. What is the outside diameter of the top most column? Is it 35mm (1.375 in.) like a Pyle Pro speaker stand?

A: Unfortunately there is no information on the diameter of the top telescope section of the stand.

Q: 2. Was is maximum extended height?

A: About 24 inches

Q: 3. I have this mount but not the necessary hardware, what hardware is included in the hardware pack?

A: Universal hardware pack includes innovative universal spacersand M4-M10 screws. Mounting kit includes wood, concrete and steel stud attachment hardwarePlease contact the manufacturer directly if you seek a replacement hardware pack:P 714.632.7100 | 800.368.9700 | F 800.832.4888 | a href= http://www.mounts.com target= _blank www.mounts.com/a

Q: 4. Is there a compatible swing hinge for this rack?

A: The manufacturer does not specify a compatible accessory of this type for the StarTech 8 RU Open-Frame Wall Mount Equipment Rack with Adjustable Depth (Black).

Q: 5. Can SVS Prime elevation speaker mount be used with this?

A: The Pyle Pro Swivel/Adjustable Wall/Ceiling Speaker Mounts will support the weight of the SVS Prime Elevation Speakers, but we are not able to confirm whether the holes on the mounting bracket that is included with the SVS speakers will line up properly with the holes on the plate for the Pyle Pro Speaker Mounts.

Q: 6. I'm assuming there's only one mount in the box, so I need to buy two boxes to mount the pair of speakers I have. Correct?

A: Yes. If you want to mount 2 speakers, then you would need 1 mount for each speaker.

Q: 7. How much weight can this stand support?

A: Although not rated or tested by the manufacturer with any products other than laptops, I would be reluctant to recommend using this with any tip-able product over 10-12 lbs.

Q: 8. What are the surface measurements of the top part of the stand?

A: 16 3/8 x 20 1/4

Q: 9. It says on the Hive site that this large (8") Fresnel will fit the Profoto B10. Is that true?

A: Yes 100%. The following system will mount to a Profoto B10.

Q: 10. What dimensions (in mm) are the rear mounting holes arranged in?

A: The dimensions and positions of the mounting holes are not listed by Huddlecam at this time. However if you email us at askbh@bhphoto.com we can guide you towards additional literature for this product that may help.