Transmit uncompressed, 10-bit 4:2:2, 1080p60 video up to 1640' at schools, events, houses of worship, or weddings with the CINEGEARS 2000M-R Wireless 4 x 1 SDI and HDMI Video Transmission Kit. The kit includes four transmitters and one rackmount receiver. Each transmitter features one HDMI and one 3G-SDI input, and the receiver features four HDMI and four 3G-SDI outputs. The 2000M-R system also supports tally functionality via its RS-232 ports.

Your HDMI or SDI signal is carried with a low-latency rate of less than 60 ms over the license-free 5 GHz frequency band. Each transmitter can send 8 Mb/s video from up to 1640' away or 15 Mb/s video from up to 984' away. The set is also capable of HDMI-SDI cross-conversion, so you can input a signal via HDMI and output through SDI, or vice versa.

Each transmitter includes a LEMO to D-Tap cable, and they are powered by separately available AC sources or D-Tap batteries. The receiver is powered by a standard AC power plug, which is included.

Transmits Low-Latency HD Video    Uncompressed 10-Bit 4:2:2 1080p60    For Weddings, Schools, Houses of Worship    4 x Transmitters, 1 x Rackmount Receiver    Uses License-Free 5 GHz Frequency Band    Transmits 8 Mb/s Video up to 1640'    4 x Antennas on Each Unit    3G-SDI and HDMI Cross-Conversion Support    4 x LEMO to D-Tap Cables

Each transmitter sends uncompressed, 8-bit, 1080p60 video over a 5G wireless network at 8 Mb/s from up to 1640' away

Suitable for video capture and transmission at weddings, houses of worship, schools, or outdoor events

One rackmount receiver and four portable transmitters are included; each unit utilizes four antennas

Support for 3G-SDI and HDMI input and output, and HDMI-SDI cross-conversion is supported

Related Questions and Answers

Q: 1. What type of cameras and video switchers can this device worked with?

A: It can work with any camera or device as long as they have an hdmi or sdi port

Q: 2. Is this a rebranded version of this- https://www.bhphotovideo.com/c/product/1445477-REG/crystal_video_technology_beamlink_quad_quad_four_transmitters_to.html Is 60ms latency noticeable in live-switching?

A: The latency on the Crystal Video Technologies unit is a bit higher at 70ms, compared to 60ms on the Cinegears option. However in either case that is a very low latency, 60ms is 0.06 seconds and should be tough to notice.

Q: 3. Can you buy a receiver sold separately for multiple feeds into one transmitter?

A: Yes, you can. I would choose Teradek instead. Actually, I'm sending this one back.

Q: 4. This looks like the ikan Blitz 400 3G-SDI/HDMI Wireless Uncompressed Zero Delay Video System, what's the difference?

A: Not familiar with the other, but not a fan of the Ikan stuff in general. Honestly, this has been a better piece than we expected. It also does signal conversion so you can go in SDI and come out HDMI at the other end. Order an extra antenna or two and make yourself some power adaptor cables to get to 4 pin XLR if the rest of the gear is in that world. Hope this helps. Good luck!

Q: 5. Will this work on a Sony a7s2 (hdmi signal) transmitting to a SDI only monitor? will it convert the signal on its own?

A: The Cinegears Ghost-Eye supports HDMI to SDI cross conversion. You will be able to put an HDMI signal in to the transmitter and connect the receiver to an SDI monitor.

Q: 6. How many transmitters can like to receiver?

A: While you can have several receivers picking up from one transmitter, you can't have it the other way around. One receiver cannot differentiate several signals. f you have several cameras, you will need to pair one transmitter from each camera to one receiver. You then put the signals into a professional video switcher.

Q: 7. CINEGEARS Ghost-Eye 150M V2 Wireless HDMI/3G-SDI Transmission Kit (984') use with Red/ Alexa camera?

A: Yes, if the camera has an SDI or HDMI output you can use them with the Ghost-Eye 150m V2.

Q: 8. 0 delay? Is this intended for live video?

A: The 2000M-H system is rated at 60 MS for latency. It is very low in latency and can be used for live video.

Q: 9. Hi, probably a dumb question but, can you plug the transmitter to an on-camera monitor via loop through or does it has to be connected directly into the camera? Thank you.

A: Yes as long as there is a signal you can plug in through anything cheers It's good but don't be fooled by the 100M distance blurb, I'd say mine only does 70M max

Q: 10. Are the recievers and transmitters weatherproof ? I mean you rarely need 2000m transmission indoors.

A: This are not weatherproof products.