The 300W Single Power Supply from QNAP is designed for select models of their NAS units. It can also be used as a second power supply for units that require redundant power. Compatible NAS models include the TS-1273U-RP, TS-877XU-RP, TS-883XU-RP, TS-1277XU-RP, TS-1283XU-RP, TVS-872XU-RP, and TVS-1272XU-RP.

For Select QNAP NAS Units    300W Single Power Supply Unit

Related Questions and Answers

Q: 1. Does it compatible with arriflex 435es advanced camera?

A: The ARRI Power Supply Light 24V will power any Arriflex 435 including the 435 ES Advanced.

Q: 2. How is this powered may I ask please? Does this convert a mic terminated with a 4 pin to work with XLR? Will I need to phantom power afterwards?

A: The device requires 48V phantom power on the XLR side. I'm using it with a Zoom H4n, with phantom power enabled. I asked this same question to the audio-technical people, and they said that you need to send phantom power to the microphone through the AT8539 and that can come from either a recording device such as a mixer (the H4n, in my case) or an external phantom power supply, such as the AT8801. Hope this helps.

Q: 3. Could I use this network card on my PC to connect to a Qnap TS-531x NAS to create a 10g connection?

A: Yes, the QNAP Single-Port (10GBase-T) 10GBe Network Expansion Card, Pcie Gen3 X4, Low-Profile Bracket Pre-Loaded B&H # QNQXG10G1T supports QTS 4.3.4.0486 or newer, Windows and Linux.

Q: 4. What's the length of the cable?

A: The Blackmagic Design URSA power supply offers a 46inch cable.

Q: 5. Can we use PX3 pro amp for hometheater setup and home or this is for commercial purpose like events and functions .. thanks

A: This is generally used for either amplifying PA speakers or for commercial use. Usually home entertainment speakers require an amplifier that pushes a different impedance. This amp does 300w at 8ohms per channel and 500w at 4ohms per channel. Most home entertainment speakers run at 6ohms and are generally a lower wattage.

Q: 6. Is the TVS-h874 supported?

A: The QNAP 350W Power Supply Unit BH #QNPWPS350WFS is not listed for the TVS-h874.

Q: 7. Could this be used as a replacement PSU for a Synology DS1515+?

A: As this is a part for a QNAP product, it is recommended that you use only authentic Synology parts for Synology products.

Q: 8. What flash trigger should I use with this lighting kit? I use Fujifilm cameras like the XT4 and XS10. Thank you!

A: The pocketwizard plusx 2 pack is a great way to work.

Q: 9. Can I install this card in a Mac (older Mac Pro that allows addin cards)?

A: This card was designed specifically to work with QNap NAS.

Q: 10. Is this a clone of the discontinued Aquantica AQN-107 ? That was a GREAT NIC !!!!

A: I wouldn't say this would be a clone, it is a highly reviewed network card.