Rosco Fluorescent Lighting Sleeves/Tube Guards are a very reliable and cost-effective system for easy control of tough lighting scenarios- especially under fluorescents. In addition to the financial benefits of the sleeves, they protect against the potential disaster of glass shattering by containing the lamp within the end caps.

Rosco sleeves are constructed of a solid polycarbonate tube within which is held the specific filter. The choice of filters and combination of filters is endless - there are complete Roscolux, Cinegel or E-Colour color filter lines - something for every venue, every photographer, every cinematographer.

For T12 Lamps    Over 300 Colors Available    UL94HB Rated Polycarbonate    End Caps Protect From Shattered Glass    Easily Trimmed with Scissors

Available in sizes for T12, T8 and T5 fluorescent lamps

The T8 and T5 sizes contain a UV filter that minimizes fading

All standard sizes (2, 4, 5, and 8') are easily trimmed to accommodate any size lamp

Related Questions and Answers

Q: 1. Can I use something like this on sheet film? I'm new to the darkroom and open to being taught. How do you remove excess water from sheet film???

A: I think it is best to hang sheet film by one corner and let it drip dry, after a 15 second photo-flo bath.

Q: 2. Can I use a USB C power bank to Feed this light?

A: Unfortunately, a USB-C power bank cannot be used to feed power into the Rotolight Neo 3.

Q: 3. Does this bulb work for the Flashpoint Xplor 600 pro?

A: Unfortunately, this flashtube has not been tested with any other flash unit other than the Godox AD600 Pro. Your results may vary.

Q: 4. Will this flash tube work on an older Sunpak MS -4000 Monolight?

A: This flash tube is only compatible with the Godox AD600 Pro.

Q: 5. I have the Wistro AD600B (not the pro) will this bulb work?

A: This flash tube is only compatible with the AD600 Pro. Unfortunately, we do not carry the flashtube for the AD600B at this time.

Q: 6. Does this work as a phono preamp for moving magnet and moving coil?

A: Yes. It will work fine with either.

Q: 7. How many 8' Pipeline Reflect fixtures can be run from one power supply? Can a splitter be used? Also, all the pipeline reflects seem to have a 3 pin, but the 8' calls out a 4 pin XLR. Does that work with their 3 pin power supply? Also, what yoke would you sue if attaching to a pipe clamp in a grid?

A: Each BB&S Lighting Pipeline Reflect (5600K, 8') uses its own power supply. I draws to much power to split, It is BH #BBS3694 • MFR #BBS-3694, https://bhpho.to/3DN9XLf . And the yoke is BH #BBS6423 • MFR #BBS-6423, https://bhpho.to/3WkYD08

Q: 8. Does this come with a mounting screw?

A: The RPS Lighting Adjustable Accessory Shoe does not include a 1/4 20 mounting screw.

Q: 9. In order to purchase clamps, how thick is the pipe?

A: The thickness of this Truss Piping is​ 1.5" inches.

Q: 10. Will these replace for Bowens XMT500? The pin orientation looks very similar.

A: No, this Godox Flash Tube is only for the AD600 Pro Monolight.