Bebob high load batteries are designed to be mounted on cinema cameras via optional adapters that allow for 20A of discharge current. When used without an adapter, they support up to a 10A draw. The Bebob V290RM-CINE 14.8V 293Wh High Load V-Mount Li-Ion Battery is compatible with the ARRI BAB-HV V-mount battery adapter for the Alexa LF, the Bebob ML-120V/V HL V-mount adapter, and the Bebob CINE-VMM-HL V-mount adapter. The battery and adapter safely combine to continuously deliver 20A with no risk to the connector pins nor the battery cells.

In addition to all this, Bebob batteries are designed to be strong, reliable, and versatile. This battery is built to withstand falls from 4.9', yet, if it cracks for some other reason, any mechanical component is replaceable by Bebob thanks to the modular design. Similarly, when the battery capacity weakens after years of use, the batteries can be re-celled at a discount by Bebob. To help decide when to re-cell, a status alarm is built into the battery that triggers a yellow LED indicator when the capacity drops below 80% over time and a red LED when below 60%.

Another flexible aspect is the twist D-Tap. Normally you're limited to connecting a D-Tap cable only one way, the way it fits. But the V290RM-CINE's twist D-Tap features three pins, a positive ground pin in the center and a negative one on each side of the positive. You can plug in your cable one way or flip it around and connect it the other way. The V290RM-CINE also provides a USB port for charging your mobile devices on location.

The V290RM-CINE features lithium-ion trimix cells made in Japan and offers a capacity of 293Wh. It has a 5-step LED fuel gauge and is compatible with Bebob, IDX, and Sony chargers. Charging time is approximately 3 hours when using Bebob VS2/VS4 chargers.

20A Maximum Load with Optional Adapter    10A Load without Adapter    5-Step LED Fuel Gauge    Withstands Falls from up to 4.9'    Replaceable Mechanical Components    Re-Cell Capable (Re-Cell Status Alarm)    Twist D-Tap    USB Port

• 20A draw with an optional adapter; 10A without an adapter
• 5-step LED fuel gauge
• Withstands falls from up to 4.9'
• Modular design allows any mechanical component to be replaced
• Can be re-celled at a discount when capacity weakens after years of use (capacity status alarm LEDs built-in)
• Twist D-Tap (allows inserting cable from either side)
• USB port
• Compatible with Bebob, IDX, and Sony chargers

Related Questions and Answers

Q: 1. Can the USB port be used to power an LED light?

A: It will depend on the light. The USB port outputs 5V at 1 amp. It should charge most devices (albeit slowly), but depending on the power consumption of the light, it might not be enough to fully power it.

Q: 2. Can this power Aputure LS 300x ?

A: Yes, the output voltage of the Bebob Cine Series is 14.4V, which is perfect for the Aputure LS 300X.

Q: 3. Will this be able to power smallhd 1303monitor with a Teradek bolt?

A: Hi Samuel, Yes - the 43Wh would power the monitor for about 25min, the 98 Wh version around 50 minutes. Best regards!

Q: 4. will this battery charge on an Anton Bauer twin charger?

A: no this battery will probably not charge on an Anton Bauer charger because Anton Bauer chargers will only charge Anton Bauer batteries

Q: 5. Would having this on a Komodo or v raptor prevent the ski ground loop since the camera doesn’t need to turn off?

A: Even if hot swapping using the bebob MLmicro 14.4V 43Wh V-Mount Li-Ion Battery, to prevent damage to SDI Outputs RED recommends following the instructions at this link: https://bhpho.to/3Ka6I3a.

Q: 6. Could these charge with Watson Pro C-AM-4E charger?

A: Yes, the bebob V240 Micro 14.4V, 238Wh V-Mount Li-Ion Battery can charge on the Watson Pro Quad Position Li-Ion Simultaneous Battery Charger (Gold Mount) when using a V-Mount to gold mount adapter.

Q: 7. Will this battery charge on my Sony BC-L50 charger?

A: Yes it should.

Q: 8. Will the above battery be considered compatible with the wooden camera product BH #HAVLMFS5 • MFR #VLM-FS5 ?

A: yes this V-mount battery will work on that Hawkwood V mount plate

Q: 9. I assume these can be charged using a Blueshape charger, even though it isn't mentioned in the compatibility list?

A: Yes, you can use a Blueshap charger to charge Bebob Vmicro batteries.

Q: 10. Will these charge on RED brick charger?

A: No this will not charge on the RED brick charger