The 5/8" Baby Pin Adapter with Safety Cable for LT120 and LT200 Light Truss from Pro Cyc permits the American Grip stands that come with the PC80 and PC160 portable green screens to be used as light stands. The adapter covers the threads on the end of the crossbar support to convert it to a standard 5/8" stud. The pin comes with a safety cable for hazard prevention.

For American Grip Stands    Converts Threads to 5/8" Pin

Related Questions and Answers

Q: 1. Can you remove the 3/8 male threads to make it female? or is it fixed?

A: The set screw is not designed to be removed. It is fixed into place with red locktite and would require a torch to loosen and remove.

Q: 2. I don't see how to lock the tilt in the pictures. Is there a way to do this? Do you need a tool or by hand?

A: Yes. Tilt is all based on tension control which is adjusted by two Allen key screws at the bottom of the next of the tilt.

Q: 3. Can this C clamp be securely mounted to a round pipe?

A: Yes, the Matthews C - Clamp with 2- 5/8" Baby Pins - 4" can adapt to round pipes.

Q: 4. Is this mount compatible with the smallhd 4k 13" monitor?

A: Yes, the E-Image VESA to 5/8" Baby Pin Adapter Female is compatible with the SmallHD Cine 13 UHD 4K High-Bright Monitor.

Q: 5. Does this come with the pictured carabiner?

A: Yes, the Impact Safety Cable (41") comes with a carabiner.

Q: 6. Is the junior pin the same length as the Avenger adapter? The Avenger adapter is too long to fit in Matthews 4.5 grip heads.

A: I think there are different lengths. Technically the Junior designation is only about the diameter

Q: 7. Are the pins collapsable for mounting a ball head on the screw?

A: No, the pins on the amaran Baby Pin Adapter to 3/8"-16 Screw are not collapsible.

Q: 8. What’s the length of the 3/8”-16 thread?

A: The female thread is 35mm. The male thread is 20mm.

Q: 9. What is the pin length? 3inch?

A: The length is 3.5".

Q: 10. Is there a 1/4” 20 version of this?

A: There is only this version with the 3/8 thread.