This Aladdin AC Power Supply provides 100 to 240 VAC mains current to power Fabric-Lite 200W, Fabric-Lite 350W, Bi-Flex4, and Bi-Fabric4 lights.

Compatible with Fabric-Lite 200W, Fabric-Lite 350W, Bi-Flex4, and Bi-Fabric4 Lights

Related Questions and Answers

Q: 1. Could work for 110v?

A: The Tether Tools ONsite D-Tap to AC Power Supply (220V) only supports 220v output.

Q: 2. Can this be used to charge a V-Mount Battery via the D-Tap port directly in a car? Or is it just a accessory to the ONsite d-Tap AC Power Supply?

A: The ONsite AC Power Supply Car Adapter will not plug directly into D-Tap battery for charging. You would require the Tether Tools ONsite D-Tap to AC Power Supply https://www.bhphotovideo.com/c/product/1438942-REG/tether_tools_sdac110_onsite_d_tap_to_ac.html?sts=pi&pim=Y to plug into the ONsite AC Power Supply Car Adapter. You would then use the charging cable provided with your D-Tap battery to plug into the ONsite AC Power Supply Car Adapter.

Q: 3. Will this work with the EOS R?

A: Yes, the Bescor DRE6K LPE6 Coupler & AC Power Supply Kit is compatible with the Canon EOS R camera.

Q: 4. Does this power supply also charge rechargable batteries when plugged in?

A: The light has no charger circuitry to do that.

Q: 5. Will this work with the Canon 90D?

A: Yep! It absolutely will!

Q: 6. How many volts and how many amps does it output?

A: Hi Taylor, the MX-Charge power supply outputs 7.5W, 1.5A. If you are looking for a 3rd party solution be advised not all USB-C power supplies will run the MixPre series in full power mode. To avoid low-power mode, the MixPre requires a USB power source that flags that it can output 7.5W (1.5A). Many USB power sources can output 7.5W but do not flag that they can do so - these will cause the MixPre to operate in low power mode (maximum two phantom mics, no HDMI in). Use the following for full power:MX-Charge accessoryDual USB-A to USB-C cableApple USB-C power adapter New MacBook Pro USB-C portAny USB power source that flags that it can output 7.5W I hope this is helpful!

Q: 7. What is the polarity of the DC plug please?

A: The inner pin is hot. The outer circle is GND.

Q: 8. How long is the power cord?

A: Hello! The entire unit from the end of the Battery Coupler to Wall Plug measures 13 feet long.

Q: 9. Work with yongnuo 300 II?

A: Sorry, no. This power is 12VAC while the light is 8VAC. The manufacturer has not provided any substitute at this time. I suggest looking on line for a AC power adapter for this.

Q: 10. There are reports that these non-Canon AC adapters will not work with the EOS Webcam Utility. Can you verify that this adapter will work with a Canon 70D and the Canon Webcam Utility?

A: We are not aware of such a problem; however, only Canon AC adapters are recommended for use with the Webcam Utility.