One of several sizes offered by RigWheels, this set of four 3" Stand-Offs with 1/4"-20 Threads can be used with standard grip heads in a variety of camera or grip rigs.

3" Long with 1/4"-20 Threads    Fits Standard Grip Heads    All-Purpose Rigging Component    3/4" Deep Threads    Use in Variety of Camera/Grip Rigs    Made in the USA

Related Questions and Answers

Q: 1. Does this include 1/4-20" screws to attach to a tripod foot, or are additional screws needed to attach the cheeseplate?

A: It does not include 1/4"-20 screws. The plate includes four M4 screws. Your tripod foot should have a 1/4"-20 or 3/8"-16 screw or thread to attach to the CAMVATE Multifunction Cheese Plate.

Q: 2. Is the t-shaped handle available as a spare part ??

A: We do not have just the T-Handle as a separate part on our website.

Q: 3. Can this be used to mount my Nanlite Forza 500 COB light to my impact heavy duty light stand? The spigot the light stand comes with is too small and flimsy, I'm look for something more robust that will give more stability to this set up. Thanks

A: Yes, the Impact Double-Ended Spigot with 5/8" Stud will work with the Nanlite Forza 500 and will be more supported by it.

Q: 4. Can I use this as a VESA for a laptop mount tray, and connect the VESA to a 1/4 boom arm? In Little words, can I use this as a adaptor for a laptop mount tray connected to a boom arm?

A: The VESA Compatibility on this CAMVATE Multifunction Cheese Plate with 1/4"-20 and 3/8"-16 Threads would be 75 mm.

Q: 5. What is the diameter (in mm) of these tubes?

A: Each individual part from the RigWheels 6" Stand-Offs with 1/4"-20 Threads (Set of 4) (B&H# RISO14X64PC) is 6" (about 15.2cm) long and about 2/3" (16.7mm) in diameter.

Q: 6. Will this clamp unscrew far enough to fit the main pole diameter of a universal C stand?

A: This clamp has a range between 0.12 to 1.65 inches. The C-Stand will need to have a diameter between those numbers for it to clamp on to it.

Q: 7. Is this product appropriate length and thread to mount a camera on a c-stand grip head for overhead flat lay photography?

A: Yes.

Q: 8. If I use this 3.5" spigot on the light stand BH #IMLS96HABI and then mount the grid head BH #IMKCP200B, should I use the top locking knob screw hole on the grip head or the bottom one to secure the head? Or this spigot doesn't work with the grip head at all?

A: It will work

Q: 9. Is this just for ONE spigot???

A: The Impact Double-Ended Spigot with 5/8" Stud and 1/4"-20 Threads is a single spigot.

Q: 10. Will this fit the Tilta Advanced Ring for the RS2?

A: Yes, the CAMVATE Super Crab Clamp will fit the Tilta Advanced Ring Grip.