The 810 Zircon Diffusion 1 Filter from LEE Filters can be used to soften the output of an LED light fixture. This filter is constructed from 180-micron polyester that resists fading from LED light fixtures and is delivered as a 4 x 10' roll.

While in use, the 810 Zircon Diffusion 1 Filter is designed to exhibit a 0.37 density, provide a 1.3-stop value, and transmit light at 43%. It can also be applied close to an LED light fixture to blur the appearance of its individual pixels.

For LED Light Fixtures    Softens Light Output    1.3-Stop Reduction    0.37 Density    43% Light Transmission    Fade Resistant    Can Blur LED Chip Pixels    180-Micron Polyester Construction

Related Questions and Answers

Q: 1. I have an amaran 672s and was wondering how these would work with the light. Do they slide down between the front cover and the light itself? Do they somehow adhere? Thanks for the help.

A: The following Gels can be gaffers tapped to the frame of the Amaran 672. For a clean install we suggest the following. Impact Universal Filter Holder - 12x12" (30.5 x 30.5 cm) B&H # IMUFHQ MFR # 3312-MK2 https://bhpho.to/3kVKJ3C

Q: 2. which gel would convert 5600k to 3200k? my lights are 5600K not 6500.

A: In your case you would want to use 3/4 cto.

Q: 3. would this work on aputure 120d ii? would it melt away or will stay fine

A: These gels can be used on an Aputure C120D II. While LED lights produce much less height, it is always a good idea to attach the gels with a bit of air space between them and the light.

Q: 4. Can this filter be used on a regular speedlight or is it only for strobes?

A: Sure! These high-quality acetate sheets can easily be cut down to fit any size required. You can simply rubberband a piece around the head of your speedlight or cut it for use inside a fitted plastic diffuser. Easy-peasy!

Q: 5. can these be used to warm up par 38 led bright white floods?

A: Yes these CTO filters can be used to warm an LED light source with a cooler color temperature.

Q: 6. Is this fireproof?

A: No, the LEE Filters Quick Location Pack - 24 Sheets (10 x 12") listed above are not fireproof. According to LEE Filters, they state that their standard gels are "heat resistant" to 180° degrees Centigrade (356° Fahrenheit). The filters should be used at a slight distance from halogen, tungsten, and some high-intensity LED lamps, but may eventually melt and will require occasional replacement.

Q: 7. how thick?

A: Its about the thickness of a couple of pieces of paper.

Q: 8. Is this fire proof?

A: These gels would not be fire proof. Sufficient air space between the gel and the light would be needed.

Q: 9. Do those filters compatible with aputure light dome II ?

A: Yes they are fully compatible

Q: 10. In what light can I use it? Reflector? Could you advise me?

A: These gels are small sheets, slightly smaller than a sheet of office paper. They are not intended for large and powerful lights, which require a roll of gel rather than a sheet. These are best used on lights with a suitably small lens/aperture, such as a small LED panel or a fresnel like the Arri 650 or lower. If you are using hot lights, keep them a few inches away or the heat will melt them. They are fantastic for coloring smaller LED lights.