Incorporating CoreSWX's VoltBridge technology for wireless managing of your fleet of batteries, the CoreSWX VoltBridge Enabled Fleet Micro 3A Digital Quad Charger for Gold Mount Batteries is capable of simultaneously charging four batteries at 3A each. This means that four 98Wh batteries can be charged in under 2.5 hours. The onboard LCD display screen allows you to easily monitor your battery's smart data without needing to connect to a computer. The micro-USB connector allows for firmware updates and for connection to a PC.

The built-in Battery Management Test mode allows the charger to determine battery health and recharge performance. Activating the SafeFly mode forces the charger to discharge or charge connected batteries to a 30% charge level to meet air travel and shipping requirements. While plugged into an AC power source, the charger can either charge batteries or be used as a camera power supply via the built-in 4-pin XLR. In the absence of AC power, you can use the charger to feed the 4-pin XLR from connected batteries providing unregulated power. The housing is made of aluminum, providing a robust build.

VoltBridge Wireless Battery Management    Four-Position Gold Mount Charger    Charge Current: 3A    Simultaneously Charge Four Batteries    4 x 98Wh Packs Charge in Under 2.5 Hours    Onboard LCD Display Screen    Battery Management Test Mode    SafeFly Charge/Discharge Mode    Worldwide Compatible 90-240 VAC Input    4-Pin XLR Powered DC Output

• The charger incorporates VoltBridge technology which enables you to remotely view your attached batteries status via a mobile device app; the app also allows you to have the charger put your attached batteries into SafeFly mode
• Accessing the chargers control panel provides the same management capabilities as the VoltBridge app, without the same convenience
• Four independent Gold mount charge bays
• Simultaneous charging
• Approximately 2.5-hour charge time for four 98Wh batteries
• When SafeFly mode is activated, the charger will either discharge your battery down to 30% of capacity or charge it up to 30%, depending on the charge state of the battery
• 90 to 240 VAC worldwide compatible input voltage
• Compatible with batteries from RED, Anton Bauer, and others in addition to CoreSWX
• The four-line LCD display screen enables monitoring battery information from the charger
• Hypercine mode allows you to mount up to four batteries to provide unregulated 12 to 16.8 VDC from the charger's 4-pin XLR, without connecting to an AC power supply
• In Hypercine mode, the charger's LCD reports back available capacity as well as remaining runtime
• Aluminum build
• Weighs 5 pounds
• An optional "Hypercine Module" (not included) enables the charger to provide both unregulated 12 to 16.8 VDC and regulated 28 VDC via a 3-pin XLR output

Related Questions and Answers

Q: 1. Can this battery legally travel airborne?

A: You will want to check with your airline directly as restrictions on batteries frequently change. At this time you can travel with batteries that are above 100 Wh, you may just need to first get approval from the airline.

Q: 2. s it safe to charge IDX CUE-D150 v-lock batteries on this?

A: The truth is all gold mount and v-mount chargers can charge all gold mount and v-mount batteries. But note this other truth: manufacturers do not support this action. What this means if a problem or damage occurs, then they will not do warranty repair on either the charger or battery. You are on your own.

Q: 3. Is this battery really air-travel friendly, UN tested for air travel, even though it's above the TSA 98Wh limit?

A: Switronix is scrupulous in it's attention as to the suitability of their batteries for air travel. However, there is an error on the B&H site. The UN tested and certified for air travel is for only the 98 version. I shall alert the B&H Webteam as to the error. We apologize for any confusion and inconvenience this may have caused.

Q: 4. Can this charge Blueshape Granite mini 140wh batteries?

A: In most instances, the Core SWX Fleet Q V-Mount Four-Position Charger will charge any V-mount batteries that will be connected to it, although we always recommend using equally branded chargers with their counterpart batteries whenever possible, as those would ensure full compatibility and most adequate charging speeds.

Q: 5. Can the charger provide XLR power while charging from AC?

A: While drawing AC power, the Core SWX Fleet Micro 3A Digital Quad Charger for V-Mount Batteries (B&H# COFLEETQM4S) can either charge the batteries or provide power through the 4-pin XLR output. You can select your preferred option of those two using the selector switch on the back of the unit. Those two alternatives cannot both be used at the same time.

Q: 6. Is this charger compatible with these batteries? Anton Bauer Logic Series Dionic 160 Digital Interactive Lithium-Ion Battery, 14.4 volts, 160 watt hours, Anton Bauer 3-Stud Gold Mount

A: Yes, it will charge all Dionic model, as well as Hytrons (NiMH) and the new AntonBauer offerings (Digital and Cine series).

Q: 7. What does Volt Bridge Enabled do if one was to choose this option?

A: The VoltBridge version of the Core SWX Fleet Micro 3A Digital Quad Charger for Gold Mount Batteries allows for wireless battery management through a mobile device app, providing remote battery status as well as the ability to put mounted batteries into SafeFly mode.

Q: 8. Can this charger be used on Anton Bauer Dionic series gold mount batteries?

A: Not that we are aware of. Anton Bauer Dionic batteries will require Anton Bauer chargers.

Q: 9. Will this fleet charger charge the XP-L90A battery model?

A: Yes this charger should work well with any Gold Mount Core SWX Battery.

Q: 10. Does this model (BH #COFLEETQ4S MFR #FLEET-Q4S) have the ability to discharge for air travel?

A: No, The SWX FLEET-Q4S will not be able to discharge batteries. The best choice with discharging support using the VoltBridge app ( Apple or Android) would be the Core SWX Fleet Q4Si https://bhpho.to/3LMVU9v