The Kino Flo FreeStyle Tube Mount Wall Plate allows a single tube to be mounted to the wall without its housing.

Mounting Choice for FreeStyle Lights

Related Questions and Answers

Q: 1. Does it fit two Diva-Lite 21s? What kind of stands can it fit?

A: Yes it will

Q: 2. Can this be mounted on a standard light stand?

A: This Impact Wall Plate can only mount to a wall or ceiling and would accept a junior pin on top.

Q: 3. Can this also be used as a junior pin?

A: Remove the screw and it should fit a junior receiver.

Q: 4. What is the dimension from the back of the plate to the far end of the receiver?

A: It is about 3 inches from the back of this plate to the far end of the receiver.

Q: 5. this is original?

A: Yes

Q: 6. Will this receive a full size C-stand riser?

A: Yes, the opening is 1 1/8 which is standard for most C stand columns.

Q: 7. Since this is a low profile mount, how much can tilt and pan does this permit when mounting 8030s?

A: Based on the assembly guide, you should be able to tilt up from 30-60 degrees from the center of the speaker, tilt down 20-30 degrees. Pan seems to show roughly 45 degrees from center position.

Q: 8. Can I use it with the Kino Flo 2' Fixture Shell for 4Bank ?

A: Yes this can work with a Kino Flo 2' 4 Bank Fixture Shell.

Q: 9. What are dimensions of the flat plate itself (not the receiver)?

A: The size of the plate is approximately 5.9x3.6".

Q: 10. How big are the holes and what' the spacing? Was thinking of putting some magnets on this and want to get some ideas on sizes

A: The larger holes are 5mm, and the smaller 3mm. From center to center the large holes are 5.5 cm apart. From center to center the small holes are 3.5 cm apart. The entire plate is approximately 7.5cm x 14.5cm