Use this 10" Lamprey Adapter from Kessler Crane to mount your camera, slider, gimbal, magic arms, and more onto a non-porous surface. The adapter has a 10" suction cup mount on one end, and 1/4"-20 and 3/8"-16 threaded holes on the other. It is compatible with the Kwik release receiver, Freefly Toad In The Hole, two Kessler sliders on both ends, Ronin 2 dovetail adapter, and the Kessler HD angle plate. The lamprey adapter features a built-in pump rated for 150 lb of force, handles, and built-in tether points for extra security.

10" Suction Cup Mount    Built-In Pump Rated for 150 lb    Built-In Tether Points & Handles    1/4"-20 & 3/8"-16 Threaded Holes

Related Questions and Answers

Q: 1. will the bottom of this plate sit flat on the table ?? with the plate attached to the camera ?

A: No, it will not. It has two screw heads protruding. They serve as catches so the plate does not slide out of the head.

Q: 2. the "plate" on the bottom, does it fit arca-swiss or Manfrotto PL type mount?

A: NO it will Not

Q: 3. Will this work on a Benro 100mm Hi Hat?

A: The best choice is the model listed below from Benro. But, the Kessler Crane 100mm to 75mm Bowl Adapter should also work with the Benro Hi Hat as well. Benro BA1075 100mm to 75mm Bowl Adapter Ring BH #BEBA1075

Q: 4. Would this be suitable for mounting a 3rd party slider to a K-pod?

A: The Kessler K-Pod requires a fluid head and then this Kessler Crane K-Plate Kwik Release Plate can be mounted to the tripod plate which attaches to the camera.

Q: 5. will it power Canons Flash?

A: No this will NOT power c anon flash

Q: 6. Should/could this be used to mount the second shooter unit to a slider that has the Quick release receiver on it?Thanks.

A: I do not have a second shooter or never used one, but I would assume you could. I have used this to attach several things to the Kessler receiver. I have the pocket jib, and I attached this to the bottom so it was easier and faster to use on a tripod. I would double check with Kessler but I would assume you would be able to.

Q: 7. How tall is it?

A: The Kessler Crane Lamprey Adapter (10") is 10inches in height.

Q: 8. I UNDERSTAND THE TIRE IS 6" DIAMETER, WHAT IS THE WIDTH? 1.5?

A: The Kessler Crane 6" All-Terrain Wheels for K-Pod (B&H# KETH1007) are about 1" (2.5cm) thick.

Q: 9. Does the vertical tilt lock down well when there is a heavy load on the head? The system we will be mounting will be 50+ lbs, and will need to sometimes be locked at an angle.

A: Yes, it locks very well. Two things...there is a locking pin that has to be pulled out and reinserted to lock the head AND the plate under the ball has to be reversed so the flat not curved side is against the ball. We use the Kessler Pocket Jib with a C300 and 45 lbs counterweight without issue.

Q: 10. Does this work with the BMPCC4k?

A: With the Blackmagic Design Pocket Cinema Camera 4K DC Cable Pack (SKU: BLCCPOC4KDC), you should be able to power your Pocket Cinema Camera with this Battery Adapter. https://www.bhphotovideo.com/c/product/1434003-REG/blackmagic_design_cable_ccpoc4k_dc_blackmagic_pocket_camera_dc.html