The Mini Cardellini Clamp from Cardellini is a smaller version of the Cardellini Clamp. Shown here in a black anodized finish, it features a 5.4" shaft with a 1/4-20 female thread that makes it suitable for tabletop work and for holding small objects like laser pointers, flags, and other accessories while mounted on a tripod or stand.

The jaws have a 1.5" capacity and feature non-marking rubber on the insides to help protect surfaces and objects from scratches while increasing friction for a stronger grip.

Jaw Clamp Suitable for Tabletop Work    Non-Marking Rubber Vulcanized on Jaws    Finish: Anodized Black    Jaw Width: 1.8"    Jaw Capacity: 1.5"    Shaft Length: 5.4"    1/4-20 Female Thread on Shaft    Weight: 7 oz

Related Questions and Answers

Q: 1. is there a mid-jaw version or only an end-jaw version?

A: Unfortunately, this clamp only comes in an end jaw version.

Q: 2. what are the actual measurements of the clamp? Not the box but the clamp itself.

A: The clamp is designed to work on 2" OD pipe. If you need more detailed dimensions, please call global truss. Tel: (323)415-6225

Q: 3. Oh for goodness sake, could you please list the maximum opening of this clamp?

A: The Mini Matthellini will open 2".

Q: 4. What is the max opening of the clamp?

A: When I open mine until it stops the outside edge gap is about 1-3/4 to 1-7/8. The inside measurement where the clamp is the widest is about 2-1/4. For example, if you were to clamp it on a book the thickest book you could clamp would be about 1-3/4 .

Q: 5. What's the distante range for the laser beam ?

A: The Cardellini Red Laser Pointer has a range of 900 meters.

Q: 6. What is the weight capacity for this without slipping on the speed rail?

A: Approximately 150 lbs.

Q: 7. Can you run a 3/8 rod all the way through both ends? If not how far in can a 3/8 rod get from one end? Thx.

A: No. The following unit has 3/8"-16 Female threads at each end of the connector.

Q: 8. Are these compatible with cForce Plus Motors?

A: No, the ARRI cforce mini Clamp Console 2 is not the correct clamp for the ARRI cforce plus motor. You should get the ARRI 19/15mm cforce Plus Clamp Console (BH #ARCFPCC1915 • MFR #K2.0008678) instead. See: https://bit.ly/3RTgsSB

Q: 9. Can you remove the ball on this and if so what size is the thread?

A: If you heat up the lock tight you can remove the ball currently 3/8-16

Q: 10. The video shows a 1/4 20 and a 3/8 tap on the mini clamp but the pict shows only one tap. Which one are you selling?

A: There is two drilled and taped holes on tip. 1/4 and 3/8.