Mount your gear securely using this silver Mini Mic Mounting Clamp from Cardellini. The aluminum and stainless steel clamp's jaw opens and closes using its threaded shaft, and it can mount onto surfaces up to 1.5" wide. The interior of the clamp is padded to protect and keep a solid grip on your gear. Mount your gear on the 3/8"-16 male thread on the end of the shaft.

Clamp Gear onto Surface up to 1.5"    3/8"-16 Male Screw Mounting Thread    Padded Inner Clamp to Protect Gear    Made from Stainless Steel and Aluminum

Related Questions and Answers

Q: 1. Is this the same as the Matthews Mini Matthellini Clamp? BH #MAMM • MFR #420112-S15? With the female 1/4" 20? But just without the "Infinity tip" at the top?

A: According to the manufacturer this stand has a 1/4" 20 male post on the end of it under the ball.

Q: 2. What are the dimensions? How big or small will this grip?

A: The jaws will go from jaw to jaw and up too 2 on square stock. The smallest DIA is 3/8 round. and 3/4 round is largest.

Q: 3. Oh for goodness sake, could you please list the maximum opening of this clamp?

A: The Mini Matthellini will open 2".

Q: 4. Can this fit a MOZA AIR 2?

A: No, the Zhiyun SmallRig Mounting Clamp for CRANE 3S will not fit the Moza Air 2 3-Axis Handheld Gimbal Stabilizer.

Q: 5. What's the distante range for the laser beam ?

A: The Cardellini Red Laser Pointer has a range of 900 meters.

Q: 6. Can you remove the ball on this and if so what size is the thread?

A: If you heat up the lock tight you can remove the ball currently 3/8-16

Q: 7. Will this work with 42mm tube? 42mm is 1.66". It's pretty close.

A: No, it will not be able to close with a pipe that is over 1.61 inches.

Q: 8. Is the hole on the top: a 1/4-20" OR is it 3/8-16" on the inside? I mean can I use a "Matthews Baby Pin 5/8" with a 3/8" Threaded Tip", into the hole - on the top of this Mini Clamp? Or do I need a "Baby Pin with a 1/4" Tip"?

A: We have two versions, one with a 1/4"-20 female threading at the end of the pin, which is what i believe you are asking about. We also have a Mini Matthellini with a male 3/8"-16 threading at the end of the pin.

Q: 9. Is the black tip/ball at the end, is it a female 3/8" 16? Or is it a male 3/8" 16?

A: The Ball has a Female 3/8”-16 receiver that threads onto the male 3/8”-16 end of the Mini Matthellini shaft.

Q: 10. It says it swivels but can it be locked into one position?

A: The clamp does not have a locking option. I would suggest that you look at our swivel clamp/n which come with a locking pin.