Designed to convert a 3/8" pin to a 5/8" pin, the Pin Adapter from Cardellini measures 2.8" in length and locks down with an optional 3/16" Allen wrench. The nickel-plated steel pin weighs 3 oz.

Converts a 3/8" Pin to a 5/8" Pin.    Nickel-Plated Steel Construction    Locks with 3/16" Allen Wrench    Length: 2.8"    Weight: 3 oz

Related Questions and Answers

Q: 1. Is this adapter threaded on the female end?

A: The female end is an non-threaded 5/8" female receiver.

Q: 2. Does this adapter work for 5-Pin DMX?

A: The Sescom NHA5F5F 5-Pin Female to 5-Pin Female Inline Adapter Barrel is an audio inline adapter, and it does not work with 5-pin DMX protocol devices.

Q: 3. What's the distante range for the laser beam ?

A: The Cardellini Red Laser Pointer has a range of 900 meters.

Q: 4. Can this be just regular Mitchell mode as well? Or does it go on OConnor only?

A: It cannot be. You will need BH #CAHLQQ for Mitchell Mount. https://bhpho.to/38WzjGU

Q: 5. Why is the Cardellini Manfrotto 492 Ball head more expensive than the Manfrotto 492 micro ball head?

A: The Cardellini Manfrotto 492 Micro Ball Head with Mic Clamp would be a combination of two different products from two different manufacturers, whereas the Manfrotto 492 Micro Ball Head (sold by itself) is a single item from a single manufacturer. As such, the Cardellini Manfrotto 492 Micro Ball Head with Mic Clamp would be higher in price compared to the ball head sold by itself.

Q: 6. I don't see how to lock the tilt in the pictures. Is there a way to do this? Do you need a tool or by hand?

A: Yes. Tilt is all based on tension control which is adjusted by two Allen key screws at the bottom of the next of the tilt.

Q: 7. Are the pins collapsable for mounting a ball head on the screw?

A: No, the pins on the amaran Baby Pin Adapter to 3/8"-16 Screw are not collapsible.

Q: 8. Is this mount compatible with the smallhd 4k 13" monitor?

A: Yes, the E-Image VESA to 5/8" Baby Pin Adapter Female is compatible with the SmallHD Cine 13 UHD 4K High-Bright Monitor.

Q: 9. Does the Mitchell head-lock fit under a O'Connor head or do I absolutely need the O'Connor head-lock for a O'Connor head?

A: The Cardellini Head-Lock with Mitchell Mount (B&H# CAHLQQ) has a 3/8"-16 male center thread that will allow very many brands of tripod heads (including some made by O'Connor) to be used with it if they are designed to mount on that thread and have a large enough base (about 3.5" or 8.9cm in diameter or larger) to be secure there.

Q: 10. Can this be used with a fujinon zoom controller to a fujinon lens or is this only for libec controller?

A: While this is designed to work as an adapter for a libec controller we believe that it should work in other scenarios where a 8-pin to 12-pin adapter is required as well.