Send audio over shielded Ethernet cable with the black SoundTools WallCAT MX-B Wall Plate. It has four male XLR terminals on the front and two Ethernet terminals on the back for passing audio over Ethernet to support long cable runs. Thanks to channel isolation, you can also send a DMX signal and balanced audio simultaneously. The double-gang wall plate is designed to fit standard electrical junction boxes, and only 1.2" of depth is required.

Four Neutrik XLR 3-Pin Male Connectors    Two Rear Amphenol Ethernet Connectors

Related Questions and Answers

Q: 1. What is the max wattage rating for this adapter plate?

A: This adapter has a 12 to 14.4 VDC Output an allows you to power equipment with a 4 Pin XLR power input with a V-Mount Battery.

Q: 2. could this mic be used to amplify wood vibrations such as drums or even a piece of wood?

A: This would be an excellent mic for your application

Q: 3. what is the warranty?

A: Included is a Limited 2-Year Warranty from Sennheiser.

Q: 4. What battery does it take?

A: The Battery The unit uses an A23 battery which is located in the Sender. The positive end of the battery should be pointed inwards, away from the cap Twist the cap to turn the unit on or off.

Q: 5. can it be ceiling mounted?

A: As long as you have adequate support from above yes. I would look to anchor all four of the bolt holes into something very solid like a floor joist from the floor above. Be careful about finding a mounting surface that will provide adequate width so that you anchor all 4 corners using the provided holes. I would not bolt this to a drywall ceiling and attach anything weighing more than a few pounds to it. If you bolt this to the ceiling then you should also consider what you are going to attach to the pin and ensure that you can grip that pin firmly enough that it can hang upside-down with all of the weight trying to pull away form the pin.

Q: 6. What is the range of this tester?

A: Maybe up to 150' but the manufacturer has not published this specification. Contact them at: support@soundtools.com

Q: 7. Is the top of the pin big enough to attach a grip head? I want to wall mount this with a 40" arm & small light over a table.

A: The Impact Wall Plate with 90-Degree Baby Pin has a standard Baby Pin, just like any light stand, it it is computable with a standard grip head.

Q: 8. What is the distance between the bigger holes on the short end?

A: From the center of each hole, we measured 65mm with a vernier caliper.

Q: 9. Is this compatible with the Matthews BabySitt'r?

A: This is a Baby 5/8 pin it's compatible with any Baby pin accessory.

Q: 10. How much weight can these support? I want to use three of these to hang a 37-pound canvas backdrop on my wall (the backdrop is mounted on a top rail made of wood with three holes for hanging).

A: These are welded steel. The weak point will be the wall and how you anchor them.