This Tilta Single 15mm Aluminum Rod is 5.91" in length and anodized gray/silver. It is compatible with 15mm LWS and studio rod support clamps and chamfered to make it easier to slide rod-mounted accessories onto the end.

Single 5.91"-Long 15mm Rod    Chamfered

Related Questions and Answers

Q: 1. Is this compatible with the Wooden Camera dovetail plate?

A: The Tilta Universal 15mm LWS Baseplate (Black) is not listed as compatible with other brands of dovetail plates.

Q: 2. Does this work with Nucleus Nano II? Or just the first version?

A: Yes, the Tilta Nucleus Nano Motor Adapter for Tilta Mirage (Single 15mm Rod) is compatible with the Tilta Nucleus Nano II motor.

Q: 3. Will this fit the Tilta S1H cage? The LWS plate for my GH5 Tilta cage does not center the S1H lens over the 15mm rods. I want to use the S1H w/Tilta cage and a matte box.

A: The Tilta 15mm LWS Baseplate Type I (Black) (B&H# TIABSP15B) is not designed for use with the Tilta Full Camera Cage for Panasonic S1/S1R/S1H Series (Black) (B&H# TIAT38FCCB) and it will not fit properly. Rather, use the Tiltaing 15mm LWS Baseplate Type II (Black) (B&H# TIABSP215B).

Q: 4. 1/4" 20 screw or 3/8"?

A: The Tilta 15mm Single Rod Holder for Camera Cage Top (Tilta Gray) provides a 1/4"-20 screw.

Q: 5. Are the rods threaded inside?

A: They are not.

Q: 6. Would this fit in the Canon LH-E1 lens support (#CALHE1) if I remove the Y support part?

A: Yes, the Tilta 15mm LWS Rod Lens Support would fit in the bottom of the Canon LH-E1 Lens Holder after removing the Y lens adapter and using the included 3/8"-16 to 1/4"-20 adapter.

Q: 7. Will this work with the Smallrig Fx3 Half cage?

A: The Tilta 15mm LWS Baseplate Type I (Black) would only be compatible with Tilta cages.

Q: 8. Does this base plate provide standard rod height from optical center on the BMPCC6k?

A: Yes, this is designed specifically for use with the Tiltaing BMPCC 4K/6K cage and will align the camera as shown in this photo on our website. https://bit.ly/33N5zGZ

Q: 9. What is the thread size?

A: It is standard, universal thread for 15mm rods.

Q: 10. What's the minimum height you can achieve with the 1/4" adapter attached? I have 1cm clearance between the tip of the rod and the foot of the lens. Need to bolt it in as a v-mount still allows the lens to move.

A: Tilta has informed us that the minimum height is 2 inches on the Tilta 15mm LWS Rod Lens Support with the 1/4"-20 adapter.