You are using an outdated browser. For a faster, safer browsing experience, upgrade for free today.
Phones: 800
$ USD
  • Your shopping cart is empty!

Chief Fsb-4229s Custom Interface Bracket For Chief Small Flat Panel Mounts (silver )

Chief Fsb-4229s Custom Interface Bracket For Chief Small Flat Panel Mounts (silver )
  • Product Code: ga69079
  • Availability: In Stock

$122.40 $173.81

The Chief FSB-4229S is a custom interface bracket compatible with all F-series and K-series mounts (except the FSR and FTR). The FSB interface brackets allow a non-VESA compatible screen to be installed on any Chief Small Flat Panel Mounting Solution.

This bracket can also be used for FSP and FDP Pole Mounts as well as FSM and FPM Wall Mounts (which are pre-equipped with an FSB bracket), if you wish to reconfigure them for a different display.

To confirm the compatibility of this mount with your flat panel TV or monitor, visit Chief's MountFinder Pro.

Required for the following mounts:

  • FWP110 Flat Panel Pivot/Tilt Wall Mount
  • FWS110 Flat Panel Single Swing Arm Wall Mount
  • FWD110 Flat Panel Dual Swing Arm Wall Mount
  • KWV110 Height-Adjustable Single Swing Arm Wall Mount
  • KWG110 Height-Adjustable Dual Swing Arm Wall Mount
  • KWB110 Height-Adjustable Triple Swing Arm Wall Mount
  • KCV110 Height-Adjustable Single Arm Desk Mount
  • KCS110 Single Swing Arm Desk Mount
  • KCG110 Height-Adjustable Dual Arm Desk Mount
  • KCD110 Dual Swing Arm Desk Mount
  • KCB110 Height-Adjustable Triple Arm Desk Mount
  • KPP110 Pivot/Tilt Pole Mount
  • KPS110 Single Swing Arm Pole Mount
  • KPD110 Dual Swing Arm Pole Mount
  • KCY220 Height-Adjustable Dual Arm Dual Monitor Desk Mount
  • KGL220 Height-Adjustable Monitor/Laptop Dual Swing Arm Desk Mount

    The mounts are compatible with VESA compliant displays (75 x 75mm or 100 x 100mm)

    Related Questions and Answers

    Q: 1. can you use 2 extension together?

    A: No, you can not couple two 4-6' extension columns.

    Q: 2. What is the max capacity? Max Loud?

    A: The capacity of the Chief PAC-770 Heavy Duty Casters is based on the cart you are using them with.

    Q: 3. What size poles do these mounts attach to?

    A: The Premier Mounts PSD-HDCA Heavy-Duty Clamp Adapter & Flat-Panel Mount (Black), B&H # PRPSDHDCA, is designed to attach to poles with a 2" outer diameter.

    Q: 4. Is there a template for mounting

    A: NO! Completely unnecessary! Figure the center of where you want the tv, left,right and up,down and mark it with a pencil. Before removing uprights spread them out to max and that is the most they can be mounted apart from each other on the wall. I would subtract an inch to avoid problems. Ideally you want to mount them 22-26 inches apart at the same height. It is all dictated by where your studs are located. Just dont mount to close together, less than 16 inches apart you best keep it centered all the time. Remove the uprights from the crossbars. You can use the same upright to mark both sets of holes. Your template. Use hardware capable of bearing the load(250lbs). If they are mounted at different heights as long as not to much. Half inch or so. There are screws at the top of each to level the bars perfectly. This is probably the BEST TV stand for sale anywhere! GOOD LUCK!!!

    Q: 5. not able to find a button to buy?

    A: Click on the blue "Add to Cart"

    Q: 6. Can i mount an ASUS 34in monitor that ways 24.7 lb / 11.2 kg to this stand?

    A: Please note the weight restriction listed below:The ASUS monitor needs to offer one of these compatible VESA mounting standards: 75 x 75mm / 100 x 100mm Compatible Supports Displays Up to 22 lb.

    Q: 7. Can the height be adjusted? It is adjustable on the CB-Junior bracket.

    A: No.

    Q: 8. Do they make a TV mount not projector that goes to this?

    A: Depending on the TV and with the proper column and and mount you should be able to mount a TV.

    Q: 9. Will this work on the dell u2715hc?

    A: The Chief KSA1250B-2 Quick-Connect Interface for Select Dell Monitors (Black) BH #CHKSA1250B2 is designed only for those Dell monitors with Dell Quick Release slots and for use exclusively with the Chief Kontour Monitor Arm.

    Q: 10. Does this bracket work for left eye shooters? I turn my camera counter clockwise (right hand on top) when I shoot vertical, so will this bracket allow the flash to stay on top? Thank you!

    A: I am actually left eye dominant myself! The bracket can be mounted to the camera from either side, but I actually mount it with the bracket to the left. I rotate clockwise for verticals-that is just me. What Bob B. stated is completely true. This is a really nice bracket, regardless of dominant eye. One can pretty much mount and shoot however he/she chooses. There is a great you tube video that was the reason I purchased it.

  • 21/09/2024

    fits and looks great on my chief mount system. I would also like to see a silver color to match the mount itself.

    5
    04/07/2024

    Extension tube works flawlessly with ceiling plate and mounting gear for projector. I can hang on the the thing it's so well built!

    5

    Write a review

    Note: HTML is not translated!
        Bad           Good
    Captcha

    Products You May Like

    Shape Vlogging Kit For Iphone

    $316.80 $408.67

    Litepanels Lpb Rechargeable Battery Pack

    $567.00 $765.45