Whether your camera is mounted on a stabilizer or your director wants to move around the set untethered, the Laizeske DRW151 SDI/HDMI Wireless Transmitter/Receiver System lets you monitor an HDMI or SDI video feed from up to 492' away on the 5 GHz band. Both the SDI and HDMI outputs on the receiver are active simultaneously, so video from a consumer-grade source can be shown on a broadcast monitor and vice versa. The transmission can be up to 1080p resolution at 60 fps, and since no compression is used, no extra artifacting will mar the image. Both the transmitter and receiver can be powered via D-Tap power source using the included power cables or with a Sony L-series battery via the built-in battery plates.

Up to 492' Line-of-Sight Range    1 Transmitter and 1 Receiver    Transmits up to 1080p60    Less than 1 Frame Latency    HDMI and SDI I/O    Simultaneously Active HDMI & SDI Outputs    L-Series Battery Plates    Includes Hard Case

WHDI (MIMO/OFDM) technology

Uncompressed SDI and HDMI inputs/outputs

Up to 1080p 60 fps with less than 1 frame of latency

492' line-of-sight transmission distance

One transmitter can transmit to multiple receivers

AES-128 encryption

Metal construction

Power via D-Tap or Sony L-series batteries

1/4"-20 threads for securing to your rig

Supports 7-36V input voltage

Related Questions and Answers

Q: 1. whats the recommended power adapter for receiver ?

A: We recommend using this dummy battery power supply with this Vaxis Atom 500 kit. You would need one for the TX and the RX . Power2000 AC-F550 AC/DC Adapter with Sony L-Series Dummy Battery BH #POACF550 https://bhpho.to/3sbUu0D

Q: 2. Can there be multiple transmitters to one receiver?

A: Unfortunately no that is not possible.

Q: 3. These units look like the two mounting holes on the front have been removed (the HDMI version has them). Is this correct? Cheers

A: The photos are accurate and the mounting holes are on the bottom of the units.

Q: 4. If the transmitter is sending with hdmi output, will the receiver be able to output the signal through Sdi?

A: Yes, the Vaxis Atom 500 can receive an HDMI signal and send out the same signal through SDI.

Q: 5. The transmitters keep getting very hot and the picture freezes..how can we overcome this?

A: Wireless video transmitters tend to get hot without much of a workaround. It might be best to move onto a system with built in heat syncs similar to teradek.

Q: 6. Can the receiver be powered from a v-mount using a tilta v-mount to l-series adapter?

A: Yes, A V-mount battery with the Tilta Sony L-Series to V-Mount Adapter Battery Plate can power the Vaxis Atom 500.

Q: 7. What's the transmission frequency?

A: US: 5.1 to 5.9 GHz

Q: 8. if i use SDI for the transmitter, can i also use HDMI for the receiver?

A: Yes, you can use either plug on either device, it doesn't affect the signal.

Q: 9. Does this receive and sends 59.94i

A: Yes. In the following formats SDI/BNC: 1080p at 25, 29.97, 30, 50, 59.94, 60 fps 1080i at 50, 59.94 fps 720p at 60 fps HDMI: 1080p at 24, 25, 30, 50, 60 fps 1080i at 50, 60 fps 720p at 60 fps

Q: 10. latency is ?

A: This is rated at 80 ms for latency. It is very low in latency.