Enhance the dialogue of your favorite movies and TV shows with the Debut Reference Two-Way Center Channel Speaker with white baffle & oak cabinet from ELAC. When paired with your amplifier or receiver, it will primarily produce dialogue, while the rest of your speakers create the ambient sound effects. It accepts up to 120W of power and features a 55 Hz to 35 kHz frequency response. The speaker consists of a 1" cloth dome tweeter and two 5.25" woven aramid-fiber cone woofers, plus two front-firing, dual-flared slot ports for enhanced low-frequency reproduction.

Two-Way Speaker Design    Up to 120W Power Handling    1" Cloth Dome Tweeter    2x 5.25" Woven Aramid-Fiber Cone Woofers    55 Hz to 35 kHz Frequency Response    2x Front-Firing, Dual-Flared Slot Vents    Magnetic Fabric Grille Included

The Reference Series' waveguide and grille design enhance upper high-frequency response.

Two front-firing, dual-flared slot vents allow for lower noise and higher bass output for improved bass dynamics.

A full-perimeter brace that joins the top and side panels significantly lessens cabinet vibrations, minimizing cabinet coloration.

Dual cast chassis woofers provide improved stiffness for both strengthening the front baffle and minimizing chassis resonances.

Oversized ceramic magnets produce high motor strength for powerful bass reproduction.

The top and bottom plates are constructed from low carbon steel for high magnetic conductivity to maximize flux density.

Related Questions and Answers

Q: 1. The page says that these are UHF radios and that a license is required, while midland's website says they are licence-free FRS radios. Is the description here up to date?

A: There is no license needed for these radios. I will have the site corrected. Thank you for pointing out the error.

Q: 2. Is it taller than it is deep or deeper than it is tall? Cab't tell by description and images

A: Resting on a long side with the speakers facing out, it is 17 wide, 7 deep (7 3/4 including the grille), and 5 3/4 high...and the sound is great.

Q: 3. Will Denon PMA-600ne have good enough power to drive the elac debut b62?

A: It sure will.

Q: 4. Can it be wall mounted?

A: Yes. 100 %. 6.2 way to go for wall mount. Put them on wall shelves or hang etc. Important point is the breather is on front.

Q: 5. Is this device compatible with a Denon CEOL N10?

A: The Denon CEOL RCD-N10 has a RCA Subwoofer Output. It will be able to connect to the Elac Debut 2.0 with a Subwoofer (RCA) cable.

Q: 6. CAN I USE ELAC 2.0 A4.2 HAS REAR ATMOS SPEAKERS FOR dobby speaakers?

A: The ELAC Debut 2.0 A4.2 Atmos Add-On Speakers (Pair), BH # ELDA42BK, may be used for the Dolby Atmos channels.

Q: 7. Is possible to surface mount these to the ceiling to use as Atmos ceiling speakers? Thanks!

A: No. Wall brackets are included though.

Q: 8. What is the recommended caliber for these speakers?

A: Pyramid High Quality 16 Gauge Speaker Zip Wire (100' Spool) B&H # PY16HQSZW100

Q: 9. I ordered ELAC DEBUT B6.2. I have Sony STR-DH190, is there any pronblem with this matching?

A: No problem at all. These ELAC speakers are well matched to the Sony STR-DH190 Stereo Receiver.

Q: 10. Will these speakers work well as rear channel speakers with a system powered by a Yamaha RX-V485 receiver?

A: Yes they will very well as rear surround speakers.