The Ambient Recording CAXSTEL6M is a balanced stereo breakout Y-cable for the Arri Alexa Mini LF camera.

The cable is terminated with two 3-pin XLR female connectors at one end and a 6-pin LEMO male connector at the other. The length is 14" and the fan 4".

Breakout Cable for Arri Alexa Mini LF    2 x 3-Pin XLR Female Connectors    6-Pin LEMO Male Connector    14" Boot to Boot    4" Fan

Related Questions and Answers

Q: 1. Does this have a genuine LEMO brand 5-pin connector or generic 3rd party "LEMO Compatible" connector?

A: The Remote Audio Dual 3-Pin XLR to 5-Pin LEMO Audio Input Cable for ARRI ALEXA Mini (17") uses a LEMO branded LEMO connection.

Q: 2. will this work coming out of an Atomos Shogun Flame?

A: This cable is specific to the Alexa Mini. I don't believe you would be able to use this cable to send audio from any other device.

Q: 3. Is this compatible with the mini LF?

A: No, the Mini LF has a 6-pin LEMO port.

Q: 4. My JBL audio speakers are separated 43 inches approx. What is the distance between each TRS connecter in this cable??

A: This cable will not seperate this will not work with your speakers setup

Q: 5. What is the distance of the spread of 2 XLRs from the Y-junction?

A: It splits in the middle, so approximately 5 feet on each end, meaning the spread would be approximately 10 feet. Best regards, Hosa Support.

Q: 6. Does this work with Tentacle Sync TRACK E ( BH #TETRACKE )?

A: It is recommended to use Locking 3.5mm TRS cables with the Tentacle TRACK E.

Q: 7. Can I connect a mixer's phone stereo out to the 3.5mm female and use XLR to TRS female adapter to convert headphones to mono?

A: Yes you can connect the headphone output of a mixer into the 1/8'' input on the Switchcraft AudioStix adapter.

Q: 8. Is the TRS end wired for stereo unbalanced or mono balanced?

A: The DigitalFoto Solution Limited Right-Angle 6-Pin Female LEMO to 3.5mm Male TRS Audio Cable for ARRI ALEXA Mini LF is intended for stereo, line-level audio input.

Q: 9. Hi it says it is for Red and Alexa but could it work on a ZCAM E2-S6? Thank you.

A: The connection on the Z-Cam E2-S6 is 5-pin lemo.. We can only confirm that the adapter has been tested with the RED cameras listed. However, the DigitalFoto Solution Limited 00B 5-Pin LEMO to Dual 3-Pin XLR Female Adapter with Audio Cable should work with the Z-Cam E2-S6 as well.

Q: 10. how long is the length of cable from the XLR connectors to where they meet?

A: the 6' cable splits in half (3') where the mini plug end breaks into the 2 xlrs