The black Countryman E6 Omnidirectional Earset Mic, Low Gain with Detachable 2mm Cable and TA3F Connector for Audix Wireless Transmitters is a vocal microphone with an adjustable boom that weighs less than one tenth of an ounce and is designed to be used by only one person. Once adjusted, it will continually hold this shape.

The E6 earset can be used on either ear for capturing audio and rejecting unwanted sound, feedback, or surrounding noise from stage monitors or nearby speakers in houses of worship, theater, and outdoor vocal and speech applications.

The low-profile, omnidirectional E6 earset virtually disappears against the skin, so performers will forget they're wearing a mic. This version offers the lowest gain for the most powerful vocals that require the highest overload. In addition, the earset comes with three protective caps with different high-frequency response characteristics that control the amount of crispness or sibilance (response at 15 kHz). This omnidirectional E6 earset's cable terminates to a TA3F connector for direct connection to Audix B60 wireless bodypack transmitters.

For Stage, Theater, and Broadcast TV    Fits Audix Transmitters    Headroom for Strong Vocals    Detachable 2mm Diameter Cable    Stiff, Steel Boom    Includes Windscreen    3 x Protective Caps    Black and White Single Tie Cable Clips    Carrying Case

The Countryman earsets are very small, lightweight, and the least visible headworn microphones.

The classic E6 is a good choice when one person will wear the microphone. Because the boom is stiffer, it can be adjusted to fit, then stored away and quickly reworn.

The E6's stainless steel boom is tough and can be bent and re-bent to fit different performers. It is highly resistant to makeup, sweat, and moisture when used with the supplied protective caps. The earset should always have a protective cap in place to keep sweat, makeup, and other foreign material out of the microphone.

The E6 earset's flexible boom is easily shaped right on the performer's face. Changeable protective caps let you shape the frequency response for different situations or to match other microphones. This omnidirectional version includes three protective caps—+4 dB (bright), +8 dB (very bright) and +0 dB (flat)—that controls the amount of crispness or sibilance (response at 15 kHz.)

Easy adjustment keeps the mic in a comfortable position for rejecting unwanted sounds. The omnidirectional E6 earset provides more isolation and is suitable for situations where there are loud monitors, extreme feedback, or environmental noise.

The included removable, quick-swap cable detaches from the actual earset, making it completely replaceable in the event of a short or break. The replaceable cable design makes upgrading wireless microphone systems easy as they are available in a wide selection of connections to accommodate most wireless transmitters.

Related Questions and Answers

Q: 1. Can this be used with the original wireless go system?

A: Yes, the Rode Lavalier II Omnidirectional Lavalier Microphone can be used with the original Rode Wireless GO system.

Q: 2. Can you remove the locking ring?

A: The locking mechanism on the Rode Lavalier II Omnidirectional Lavalier Microphone (Black) is not standardly removable.

Q: 3. can i use this to power blackmagic micro cinema camera?

A: Since I didn't try it by myself, I can't say yes, for sure. But, regarding the spec., it should work without any problems.

Q: 4. Anyone use this with a SmallHD 500 or 700 series monitor? SmallHD makes their own but it regulates to 6.4v 2.5A, whereas this Zacuto regulates to 8v 2A. Probably a safer bet to use the SmallHD cable but I prefer the Zacuto's coiled design and length. Would love to know if anyone is safely using this with their SmallHD 502 specifically though. Thanks!

A: I use these on my 702 and 502 and they work great. Be cautious about the polarity though. One time it was plugged in backwards and fried. Could have been my cheap p-tap plate though.

Q: 5. Does this cable work with batteries having a p-tap connector? Are d-tap and p-tap compatible or exactly the same?

A: If I'm not mistaken, D-tap (named after the shape) and P-tap (abbreviated from PowerTap) are the same connector and interchangeable. In my experience, D-tap is the more common nomenclature in the UK, whereas P-tap is more common the US (and probably Canada). The only other variety I know of is Blueshape's B-tap which is propriety and a different shape.

Q: 6. I don't see it in the Body List, but does is the UC-E6 for the D5300 also?

A: Yes, the UC-E6 is compatible with the Nikon D5300.

Q: 7. Is this cable is compatible with the new Nikon D750 DSLR Camera ?Please let me know, Gracias.

A: Yes. This cable is compatible with the Nikon D750 DSLR Camera.

Q: 8. Will this cable work with the d7200

A: Yes, this cable is fully compatible with the Nikon D7200.

Q: 9. Compatible with D3500?

A: No it is not compatible with D3500 , UC-E20 is compatible Nikon UC-E20 Micro USB Cable B&H # NIUCE20

Q: 10. Is this cable compatible with the Coolpix P500?

A: Yes it is, this cable is compatible with a Nikon Coolpix P500.