The black Countryman E6 Directional Earset Mic, Low Gain with Detachable 1mm Cable and cH-Style 4-Pin Connector for Audio Technica Wireless Transmitters is a vocal microphone with an adjustable boom that weighs less than one tenth of an ounce and is designed to be used by only one person. Once adjusted, it will continually hold this shape.

The E6 earset can be used on either ear for capturing audio and rejecting unwanted sound, feedback, or surrounding noise from stage monitors or nearby speakers in houses of worship, theater, and outdoor vocal and speech applications.

The low-profile, directional E6 earset virtually disappears against the skin, so performers will forget they're wearing a mic. This version offers the lowest gain for the most powerful vocals that require the highest overload. Additionally, the earset comes with two pattern-changeable protective caps for maximum isolation and gain before feedback. This directional E6 earset's cable terminates to a cH-style 4-pin connector for direct connection to Audio Technica ATW-3201 wireless bodypack transmitters.

For Stage, Theater, and Broadcast TV    Fits Audio Technica Transmitters    Headroom for Strong Vocals    Detachable 1mm Diameter Cable    Stiff, Steel Boom    Includes Windscreen    2 x Protective Caps    Black and White Single Tie Cable Clips    Carrying Case

The Countryman earsets are very small, lightweight, and the least visible headworn microphones.

The classic E6 is a good choice when one person will wear the microphone. Because the boom is stiffer, it can be adjusted to fit, then stored away and quickly reworn.

The E6's stainless steel boom is tough and can be bent and re-bent to fit different performers. It is highly resistant to makeup, sweat, and moisture when used with the supplied protective caps. The earset should always have a protective cap in place to keep sweat, makeup, and other foreign material out of the microphone.

The E6 earset's flexible boom is easily shaped right on the performer's face. Changeable protective caps let you shape the frequency response for different situations or to match other microphones. The directional earset protective caps adjust the pattern from cardioid to hypercardioid.

Easy adjustment keeps the mic in a comfortable position for rejecting unwanted sounds. The directional E6 earset provides more isolation and is suitable for situations where there are loud monitors, extreme feedback, or environmental noise.

The included removable, quick-swap cable detaches from the actual earset, making it completely replaceable in the event of a short or break. The replaceable cable design makes upgrading wireless microphone systems easy as they are available in a wide selection of connections to accommodate most wireless transmitters.

Related Questions and Answers

Q: 1. Will the AT875R work on a Panasonic Lumix GH4? Does it plug directly in or do I need a pre amp?

A: The Audio-Technica AT875R Short Shotgun Microphone requires phantom power to operate, which is not provided directly from the 3.5mm external microphone input on the Panasonic Lumix GH4 Mirrorless Camera. To use these two components together, a device that provides a phantom-powered XLR input preamp and converts the signal to a 3.5mm microphone output is required. BH #BEDXAMICROP Beachtek DXA-MICRO-PRO Active XLR Compact Adapter is a good solution in this scenario: https://bhpho.to/3tzeD2N

Q: 2. Do both ends have 3.5mm male stereo plugs?

A: No, the Audio-Technica HP-CC Cable for ATH-M40x and ATH-M50x Headphones (Black, Coiled) BH #AUHPCC has 1 x 3.5mm end to connect to the source and a smaller connector to connect specifically to the ATH-M40x and ATH-M50x Headphones.

Q: 3. Do they offer a Flat response throughout the frequency, similar to ATH-40X or are not so good for Audio Editing? Thanks

A: The Audio-Technica Consumer ATH-M50xBT2 Wireless Over-Ear Headphones with Bluetooth sound very much like the wired version - the Audio-Technica ATH-M50x Closed-Back Monitor Headphones (B&H # AUATHM50XB) which are often purchased for editing. The overall frequency response of the ATH-M50xBT and the ATH-M40x is fairly flat and both have a slight boost in the low frequencies. When compared to the ATH-M40x, the ATH-50x and ATH-M50xBT both have more highs

Q: 4. I would like to connect AT875R to Line input in Canon 1Dx II camera, have I to add a phantom power module to run mic, and wich works properly? thanks

A: Yes you need Phantom power

Q: 5. would this mic be compatible with the canon XA-25...and if so would I need any other accesories to fit?

A: Yes. Be sure phantom power is on. You may need a spacer for it to fit nicely in the XA25's mic holder. I use a rubber pipe spacer from a bicycle light handlebar mount. O-rings will work, too. If you are shooting outside, be sure to get a fuzzy. It won't get all the wind on a windy day, but it will deal with a lot of it.a href= http://www.bhphotovideo.com/c/product/538882-REG/WindTech_MM_25_MM_25_Fur_Fitted_Microphone.html target= _blank http://www.bhphotovideo.com/c/product/538882-REG/WindTech_MM_25_MM_25_Fur_Fitted_Microphone.html/aI use a short XLR cablea href= http://www.bhphotovideo.com/c/product/845562-REG/Kopul_m4003rc_3_Pin_XLR_M_to_Angled.html target= _blank http://www.bhphotovideo.com/c/product/845562-REG/Kopul_m4003rc_3_Pin_XLR_M_to_Angled.html/a

Q: 6. does this come with the foam windshield? or do I buy it separately?

A: Mine came with the foam cover. As well as a black Audio Technica zippered bag for the mic.

Q: 7. What is the Optimal Pickup Range? looking to use it for interviews on set. I would have it over the talents head, out of frame

A: You should be able to place the Audio-Technica AT875R Short Shotgun Microphone about 3 to 5 feet overhead to capture clear audio, then adjust the distance to find the sweet spot, depending on how loud the people are speaking.

Q: 8. Is there a coiled cable compatible with these headdhones?

A: Yes, you can use the Audio-Technica HP-CC Cable for ATH-M40x and ATH-M50x Headphones - Black (B&H # AUHPCC) which is a coiled cable.

Q: 9. how does it work with a zoom h6?

A: Plug it in and turn on the phantom power and bring up the level.

Q: 10. can this mic be used with headphones for monitoring?

A: There is no headphone port on the mic. You would need to monitor the sound from the device you plug the mic into.