The 50' Magenta Active Optical DisplayPort 1.4 Plenum Cable provides a simple yet powerful solution for extending high resolution over long distances. This plug-and-play DisplayPort 1.4 cable supports up to 8K at 60 Hz and 4:4:4 color, with no compression or latency and no need for any external power.

No External Power Required    Plenum Rated    HDCP Support    Supports up to 8K Resolution

No external power required

Plug-and-play

Supports up to 8K resolution (60 Hz, 4:4:4 color)

No signal loss

EDID support

HDCP support

DisplayPort 1.4

Related Questions and Answers

Q: 1. It appears this uses 66mm gobo - is that correct and are the rosco ones the compatible?

A: Yes, Rosco Size M 66mm gobos can fit.

Q: 2. Are the mounts interchangeable? Can I buy one spot and different mounts for other lights manufacturers and swap them out?

A: Yes, the Westcott cookies are swappable for the Westcott Optical Spot by Lindsay Adler system. Please review the following item Westcott Optical Spot Mount for Profoto BH #WE4766 • MFR #4766 https://bhpho.to/3gF0pcK

Q: 3. Can you use two of these with the HP 2013 UltraSlim docking station? Side by side or is the adapter to thick?

A: We have not been able to test it out, but based off the specs, If it would work it would be a very fit. I would not recommended it.

Q: 4. How does Optical Spot compare to the Aputure Spotlight Mount Set?

A: Both can be used with Gobos. The Aputure can only be used with LED, but the Westcott Optical spot can be used with flash or LED.

Q: 5. I have intentions to use this with the 400js and also the Amaran 200d which is rated at 200W COB. Would I be able to use this safely on the Amaran 200d at 50% for continuous light use safely and without affecting warranty, or does adjusting brightness not change the Watt output? Thank you

A: Yes, teh following unit will accommodate strobes up to 600Ws, LEDs to 100W.

Q: 6. Does this cable support high refresh rates above 60Hz?

A: This cable is capable of 8k 60Hz. At lower resolutions it should be capable of higher speeds. We do not do cable testing for speeds.

Q: 7. How do I aim this spot without at least a short look with a modeling light?

A: The following unit can be used with strobe units up to 600 watts or you can use a led light as well.

Q: 8. What is the size W-L-H of the travel bag, please?

A: 7" w x 13" x7"

Q: 9. Can I use this with my Godox sk1000 with this Accessory if I Do not use a modeling light?

A: This optical spot can work on Godox units that have a Bowens fitting. However, it has not been tested to your knowledge.

Q: 10. Can I use this accessory with my Bowens Gemini 750W if I use the modeling lamp in minimum power?

A: This is not recommended for Bowens S mount strobes that use a tungsten modeling lamp.